Bedienungsanleitung Sony STR-DN840 (Seite 105 von 140) (Englisch)

581035

105

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

105US

Additional Information

On placement

• Place the receiver in a location with

adequate ventilation to prevent heat

buildup and prolong the life of the

receiver.

• Do not place the receiver near heat

sources, or in a place subject to direct

sunlight, excessive dust, or mechanical

shock.

• Do not place anything on top of the

cabinet that might block the ventilation

holes and cause malfunctions.

• Do not place the receiver near equipment

such as a TV, VCR, or tape deck. (If the

receiver is being used in combination

with a TV, VCR, or tape deck, and is

placed too close to that equipment, noise

may result, and picture quality may

suffer. This is especially likely when

using an indoor antenna (aerial).

Therefore, we recommend using an

outdoor antenna (aerial).)

• Use caution when placing the receiver on

surfaces that have been specially treated

(with wax, oil, polish, etc.) as staining or

discoloration of the surface may result.

On operation

Before connecting other equipment, be sure

to turn off and unplug the receiver.

On cleaning

Clean the cabinet, panel, and controls with

a soft cloth slightly moistened with a mild

detergent solution. Do not use any type of

abrasive pad, scouring powder, or solvent,

such as alcohol or benzine.

On Bluetooth

communication

•Bluetooth devices should be used within

approximately 10 meters (33 feet)

(unobstructed distance) of each other.

The effective communication range may

become shorter under the following

conditions.

– When a person, metal object, wall or

other obstruction is between the

devices with a Bluetooth connection

– Locations where a wireless LAN is

installed

– Around microwave ovens that are in

use

– Locations where other electromagnetic

waves occur

•Bluetooth devices and wireless LAN

(IEEE 802.11b/g) use the same frequency

band (2.4 GHz). When using your

Bluetooth device near a device with

wireless LAN capability, electromagnetic

interference may occur. This could result

in lower data transfer rates, noise, or

inability to connect. If this happens, try

the following remedies:

– Use this receiver at least 10 meters

(33 feet) away from the wireless LAN

device.

– Turn off the power to the wireless LAN

equipment when using your Bluetooth

device within 10 meters (33 feet).

– Install this receiver and Bluetooth

device as closer to each other as

possible.

• The radio waves broadcast by this

receiver may interfere with the operation

of some medical devices. Since this

interference may result in malfunction,

always turn off the power on this receiver

and Bluetooth device in the following

locations:

– In hospitals, on trains, in airplanes, at

gas stations, and any place where

flammable gasses may be present

– Near automatic doors or fire alarms

• This receiver supports security functions

that comply with the Bluetooth

specification to ensure secure connection

during communication using Bluetooth

technology. However, this security may

be insufficient depending on the setting

contents and other factors, so always be

careful when performing communication

using Bluetooth technology.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony STR-DN840 Seite 105

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sony STR-DN840

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info