Bedienungsanleitung Sony TCWE675 (Seite 22 von 24) (Englisch)

29658

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

The tape stops before the tape has been fully

rewound.

• The tape is slack. Take up the tape slack.

• If “M” is shown in the display, press MEMORY

repeatedly until “M” disappears.

• The cassette shell is bent. Use another cassette.

The Multi-AMS function does not work properly.

• One of the tracks contains a long pause, a

passage of low frequencies or very low volume,

or a gradual increase or decrease in volume.

• The space before a track is less than 4 seconds

long. Load a blank space of 4 seconds using

W REC MUTING.

• The signal strength of the left and right channels

are very different.

• There is noise in the space before a track.

• You pressed M (or m) immediately before

the beginning of the next track or immediately

after the beginning of the current track.

The Dolby NR function does not work properly

during playback.

• The Pitch Control function is on and the

frequency characteristics of the sound is altered.

Push PITCH CONTROL again to turn off the

function.

There is excessively loud tape transport noise

during fast-forwarding or rewinding.

• This noise is caused by the cassette and is not a

mechanical problem.

Troubleshooting

If you’ve experienced any of the following

difficulties while using the tape deck, use this

troubleshooting guide to help you remedy the

problem. Should the problem persist, consult

your nearest Sony dealer.

The function buttons do not work.

• The tape deck has been just turned on and does

not operate for about 3 seconds. Wait until X

stops flashing.

• Check that the cassette is loaded correctly and

the cassette holder is closed completely.

The tape deck does not play or record.

• There is no cassette in the cassette holder.

• The tape has come to the end.

• The tape is slack. Take up the tape slack.

• The record-protect tab has been removed from

the cassette (see page 20).

• Make sure the amplifier setting is correct.

• Check that the tape deck connections are secure.

• The heads and tape path are dirty. Clean them

(see page 21).

• The recording/playback head is magnetized.

Demagnetize it (see page 21).

There is excessive wow, flutter or sound drop-

out.

• The capstans and pinch rollers are dirty. Clean

them (see page 21).

There is a decrease in sound level, sound drop-

out, or poor reproduction of high frequencies./

The tape does not erase completely./Noise

increases.

• The recording/playback or erasing head and tape

path are dirty. Clean them (see page 21).

• The recording/playback or erasing head is

magnetized. Demagnetize it (see page 21).

There is hum or noise.

• The tape deck is placed near a TV or VCR.

Move the tape deck away from the TV or VCR.

• The tape deck is placed on or under the

amplifier. Move the tape deck away from the

amplifier.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sony TCWE675 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info