812378
20
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
20
Settings
5.8.-Collector / Room
5.20.-VentilatorFlap
5.21.-MinOutdoorTemperature
5.23.-TmaxOutdoor
Switch-on/switch-offtemperaturedifferenceforR1/V1:
If this temperature difference between the reference sensors is exceeded and the
other conditions are also met, then the controller switches the ventilator on. When the
temperature drops to ΔT Off, then the ventilator is switched off.
Switchingtemperatureoftheventilaorflap.
If this temperature at the outdoor sensor S3 is exceeded the controller switches the
ventilator  ap at relay R2. If the temperature drops below the controller switches the
ventilator off.
Hysteresis for thermostat function at sensor 3
By setting the hysteresis value the heating of the sensor can be adjusted.If the temper-
ature of the Tsetpoint at sensor 3 is exceeded by the set hysteresis, additional heating
at relais R2 is deactivated. If the Energy saving mode is active (see 5.16) the system
heats up until TminS3+hysteresis temperature is reached.
Switch-off temperature at sensor 3
If this value is exceeded at the applicable sensor 3, the controller switches the associ-
ated ventilator off. If the temperature falls below this value again and the other condi-
tions are also met, then the controller switches the ventilator on again.
5.4.-Tset Room
Switch-off temperature at sensor 2
If this value is exceeded at the room sensor S2, the controller switches the vebntialtior
off. If the temperature falls below this value again and the other conditions are also
met, then the controller switches the ventilator on again.
Danger
Danger
Temperature values that are set too high can lead to scalding or damage
to the system. Scalding protection must be provided by the customer!
Temperature values that are set too high can lead to scalding or damage
to the system. Scalding protection must be provided by the customer!
If the set temperature difference is too small, this may result in ineffective
operation, depending on the system and sensor positions.Special swit-
ching conditions apply for speed control (see 7.3. - Speed control V1“ on
page 23)
Caution
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sorel AIR TDC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sorel AIR TDC

Sorel AIR TDC Bedienungsanleitung - Deutsch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info