Bedienungsanleitung Sorel MHCC 24V (Seite 19 von 28) (Englisch)

812334

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

5. Settings

The basic settings for the control function of the heating circuit are applied. Basic

settings applied.

By no means does the controller replace the safety appliances on site!

Operating mode

Auto: automatic/normal operation taking into account operating times (day, comfort increase, night reduction).

Reference: fixed flow temperature independent of the outside temperature. The desired flow temperature must be set in Menu 5.8.

Reference program: e.g. for screed heating. For the next 14 days, can be found under Menu 4. different fixed flow temperatures can

be entered. After 14 days, the reference temperature of the 14th day is used continuously until the operating mode is changed. Dif-

ferent temperature values can be set in menu 5.4. for every individual day separately.

Set room controllers have no influence on the setpoint program!

If a room controller is set for the respective heating circuit, the set mode or measured room temperature has an influence

on the flow temperature of the heating circuit.

S/W Day

Summer / Winter changeover in daytime mode

If this value is exceeded at the outdoor sensor the controller automatically switches the heating circuit off = Summer mode. If the out-

door temperature drops below this value, the heating circuit is switched on again = Winter mode.

In addition to the operating times in normal daytime operation, this setting is also valid for times with activated comfort.

S/W Night

Summer/Winter changeover in night-time mode

If this value is exceeded at outdoor sensor S1 during the nighttime mode times, the controller automatically switches the heating circuit

off = Summer mode. If the outdoor temperature drops below this value, the heating circuit is switched on again = Winter mode.

Curve

Type and slope of the heating characteristic curve

The characteristic curve is used to control the heat dissipation of the heating circuit relative to the outdoor temperature. The demand

for heat differs due to factors such as the type of building, heating, insulation and outdoor temperature. For this reason, the controller

can operate with a normal straight curve (setting ‚simple‘) or split curve (setting ‚split‘).

If ‚simple‘ is selected, the curve is adjusted using the graphic diagram. While setting the slope, the controller also shows the slope

value and the calculated target flow temperature at -12 °C as a reference point.

If ‚split is selected, the curve is set in the following steps:

1. Outdoor temperature for slope change

2. Slope over outdoor temperature for change

3. Slope below outdoor temperature for change

While setting the slope, the controller also shows the slope value and the calculated target flow temperature at -12 °C as a reference

point. In case of repeated adjustment of the split curve, the settings appear in reverse order.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sorel MHCC 24V Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sorel MHCC 24V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info