Bedienungsanleitung Sorel SLC (Seite 18 von 23) (Englisch)

812388

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

Please pay attention to the technical information for the PWM/0-10V outputs.

Pressure monitor

In this menu, the system pressure monitoring can be activated through a direct sensor. As soon as the set pressure conditions are

undershot or exceeded, the set relay will switch on.

Pressure monitor

Relay turns on if the pressure goes below the minimum or exceeds the maximum.

RPS-Type

Type of pressure sensor

In this menu, you can adjust which pressure sensor is being used. Please note: If e.g. VFS1 is connected, RPS1 option is not shown.

Pmin

Minimum pressure. If this pressure is not met, the controller emits an error notification and the relay switches.

Pmax

Maximum pressure in the system. If this pressure is exceeded, the controller emits an error notification and the relay switches.

Sensor Calibration

Deviations in the temperature values displayed, for example. due to cables which are too long or sensors which are not positioned

optimally can be compensated for manually here. The settings can be made for each individual sensor in steps of 0.5 °C.

Settings are only necessary in special cases at the time of initial commissioning by the specialist. Incorrect measurement val-

ues can lead to unpredictable errors.

Commissioning

Starting commissioning help guides you in the correct order through the basic settings necessary for commissioning, and provides

brief descriptions of each parameter in the display. Pressing the ‚esc‘ key takes you back to the previous value so you can look at the

selected setting again or adjust it if desired. Pressing ‚esc‘ more than once takes you back to the selection mode, thus cancelling the

commissioning help (See " Commissioning help " on page 10).

May only be started by a specialist during commissioning! Observe the explanations for the individual parameters in these

instructions, and check whether further settings are necessary for your application.

Factory Settings

All settings can be reset, returning the controller to its delivery state.

All of the controller‘s parametrization, statistics, etc. will be lost irrevocably. The controller must then be commissioned once

again.

Time & Date

Serve to set the current time and date.

For time-dependent functions such as circulation and anti-legionella and the evaluation of system data, it is essential that

the time is accurately set on the controller. Please note that the clock continues to run for about 24 hours if the mains

voltage is interrupted, and afterward must be reset. Improper operation or an incorrect time may result in data being

cleared, recorded incorrectly or overwritten. The manufacturer accepts no liability for the recorded data!

Daylight saving time

If this function is activated, the controller automatically changes to winter time or summer time (DST, Daylight Savings Time).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sorel SLC Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sorel SLC

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info