812375
30
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
30
Special functions
Relay functions
The here explained additional functions can be assigned to unused relays. Every additional function can only be used
once. Pay special attention to the technical data of the relays („B.1. - Speci cations“ on page 5).
Relay functions
Relay functions
Caution
Caution
The indicated percentages are guide values that may vary to a greater or lesser extent depending on the sys-
tem, pump and pump stage.
The indicated percentages are guide values that may vary to a greater or lesser extent depending on the sys-
tem, pump and pump stage.. 100% is the maximum possible voltage/frequency of the controller.
6.2.6. - max. speed
6.2.7. - min. speed
6.2.8. - Setpoint
The maximum speed of the pump is speci ed here. During the setting the pump runs at the speci ed speed and the ow rate
can be determined.
Settings range: 70% to 100% / Default setting: 100%
The minimum speed of the pump at relay R1 is speci ed here. During the setting the pump runs at the speci ed speed and
the ow rate can be determined.
Settings range: (Speed from „On““ on page 30 ) to max. speed -5% / Default setting: 30%
This value is the control setpoint for variant 3 (see „6.2.1. - Variant“ on page 27). If the value at the collector sensor drops
below this, the speed is reduced. If it rises above this, the speed is increased.
Settings range: 0° to 90°C / Default setting: 60°C
6.3. - Solar bypass
Use the relay to switch a bypass valve or a bypass pump
This can direct the ow pass the storage, when the ow temperature at the bypass sensor is lower than the storage
that has to be charged.
Settings range: On; Off
6.3.1. - Variant
6.3.2. - Bypass (sensor)
This menu determines wether a pump or valve is used to direct the ow through the bypass.
Settings range: Pump, Valve / Default setting: Valve
The ow sensor for the bypass function is selected in this menu. Do not install in the return ow.
Settings range: S1-S8, VFS1, VFS2 / Default setting: none
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sorel XTDC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sorel XTDC

Sorel XTDC Bedienungsanleitung - Deutsch - 48 seiten

Sorel XTDC Bedienungsanleitung - Französisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info