Bedienungsanleitung Soundcraft MFX12 (Seite 33 von 48) (Englisch)

611455

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

USING YOUR MFX CONSOLE

The final output from your sound system can only ever be as good as the

weakest link in the chain, and especially important is the quality of the

source signal because this is the starting point of the chain. Just as you

need to become familiar with the control functions of your mixer, so you

must recognise the importance of correct choice of inputs, microphone

placement and input channel settings. However, no amount of careful

setting up can take account of the spontaneity and unpredictability of

live performance. The mixer must be set up to provide “spare” control

range to compensate for changing microphone position and the absorp-

tion effect of a large audience (different acoustic characteristics from

soundcheck to show).

MICROPHONE PLACEMENT

Careful microphone placement and the choice of a suitable type of mi-

crophone for the job is one of the essentials of successful sound rein-

forcement. The diagrams on the left show the different pick-up patterns

for the most common types of microphone. Cardioid microphones are

most sensitive to sound coming from in front, and hypercardioid micro-

phones offer even greater directivity, with a small amount of pickup be-

hind the microphone. These types are ideal for recording vocalists or

instruments, where rejection of unwanted sounds and elimination of feed-

back is important. The aim should be to place the microphone as close

as physically possible to the source, to cut out unwanted surrounding

sounds, allow a lower gain setting on the mixer and avoid feedback. Also

a well chosen and well placed microphone should not need any appre-

ciable equalisation.

There are no exact rules - let your ears be the judge. In the end, the

position that gives the desired effect is the correct position!

INITIAL SETUP

Once you have connected up your system (see the sections on connec-

tion and wiring earlier in this manual for guidance) you are ready to set

initial positions for the controls on your mixer.

Set up individual input channel as follows:

• Connect your sources (microphone, keyboard etc.) to the required

inputs.

WARNING: Phantom powered mics should be connected before

the +48V is switched on. Ensure the PA system is OFF when switch-

ing phantom power on or off.

• Set Master faders at 0, input faders at 0, and set power amplifier

levels to about 70%.

• Provide a typical performance level signal and press the PFL but-

ton on the first channel, monitoring the level on the bargraph me-

ters.

• Adjust the input gain until the meter display is in the amber sec-

tion, with occasional peaks to the first red LED at a typical maxi-

mum source level. This allows sufficient headroom to accommo-

date peaks and establishes the maximum level for normal opera-

tion (but see note below).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Soundcraft MFX12 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info