SCD8100 / English Instruction Manual
3
Select DAB radio station
Press the “ ” or “ ” or rotate the “TUNING” knob to select the desired radio station.
To confirm the selection, press the “ENTER / ” button.
Preset store
1. Select the desired radio station.
2. Press and hold the “PROG” button until “Preset Store” is shown in the display. Choose with
“ ” or “ ” or rotate the “TUNING” knob to select the desired program station number.
3. Press to confirm the “ENTER / ”.
Preset recall
1. Press the “PROG” button. “Preset Recall” is shown in the display. Choose with “ ” or
“ ” or rotate the “TUNING” knob to select the desired program station number.
2. Press to confirm the “ENTER / ”.
DAB information
Press repeatedly the “INFO / “ button to show the following DAB information:
DLS, signal strength, program type (PTY), ensemble name, frequency, signal error rate, audio
bit rate, time, date.
DAB menu
The device must be in DAB mode. To enter the DAB menu, press the “MENU” button. Select
with the “ ” or “ ” one of the following settings and press “ENTER / ”. You can press the
“INFO / “ button to go back to previous step or you press the “MENU” button to exit the DAB
menu.
• Full scan:
Starts the station scan. The DAB frequency band is scanned for stations.
• Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. Select individual frequencies and confirm with the “ENTER / ”
button.
• DRC:
Short for Digital Range Control (dynamic range). The term DRC describes the ratio between
the quietest and the loudest sound. If the dynamic range is very high there are very soft
sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
This however has the disadvantage that the loud sections become uncomfortably loud. It
makes sense here to reduce the dynamic range. Select between the options:
