Bedienungsanleitung Soundmaster URD-750 (Seite 5 von 11) (Englisch)

673313

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

4. Rotate the VOLUME control on the left side panel to adjust the volume level.

5. When you are finished listening press the ALARM OFF/POWER button to turn the unit ‘Off’.

The POWER LED indicator goes off.

Antenna Information

The AM ferrite bar antenna is inside the cabinet. If AM reception is unsatisfactory try turning the

entire unit slightly until you find the direction that provides the best reception for the desired

station.

Make sure the FM lead wire antenna is extended to it’s full length. You may have to vary the

direction of the wire antenna to find the position that provides the best reception.

Playing Compact Discs

NOTE: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs,

however the playability of CD-R/RW discs may be affected by the type of software that was used

to create the discs, as well as the quality and condition of the blank media you are using. 100%

playability cannot be guaranteed. This is not an indication of a problem with the player.

Normal Playback

1. Press the ALARM OFF/POWER button to switch the unit ‘On’. The POWER LED indicator

comes ‘On’.

2. Press the CD PLAY/PAUSE button to enter CD playing mode.

3. Press on the CD door in the area marked OPEN/CLOSE to open the door. If you have not

already done so, remove the ‘dummy CD’ transit protection card from the CD player and

discard it

4. Place your disc on the center spindle with the printed label side facing up. Press down near

the center of the disc to make sure it is firmly ‘seated’ on the spindle, press OPEN/CLOSE to

close the CD door.

5. Two dashes “cd- -“ flash while the player reads the table of contents of the disc.

The display will show the total number of tracks for a few seconds and then return to the

correct time.

To see the track number at any time during playback press the ALARM SET/DISPLAY button.

The track number will appear for several seconds and then the display returns to the correct

time.

Note: If the disc is inserted incorrectly, or if the disc is badly scratched and cannot be read by

the player, “cd00”will appear on the display for a few seconds, and then the display returns to

the correct time.

6. Press the CD PLAY/PAUSE button to begin playback.

The display will briefly show “cd: 1” (Track 1) and playback on track 1 begins.

After a few seconds the display returns to the correct time.

7. To pause briefly during playback press the CD PLAY/PAUSE button.

The two dots “ : ” in the middle of the display flashes briefly and the sound stops, but the disc

continues to spin. Press the CD PLAY/PAUSE button again to cancel pause and resume

playback.

8. To skip forward or backward to other tracks repeatedly press the TIME-DN/F.REW or

TIME-UP/F.FWD buttons until the desired track number appears in the display. Playback will

begin on the selected track.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Soundmaster URD-750 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info