Bedienungsanleitung Soundmaster URD820 (Seite 3 von 4) (Englisch)

562266

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

ENGLISH

ENG 2

POWER SUPPLY

This unit operates from a mains supply. Connect AC power cord to the AC household mains outlet.

Ensure voltage on the set corresponds to the voltage of your local area.

Remarks:

1) In case of malfunction due to electrostatic discharge (ESD), reset unit by reconnecting the AC cord

again to resume to normal operation.

2) When not in use, unplug AC power cord completely from AC mains supply.

3) The mains plug is used as the disconnection device; the disconnection device shall be readily

operable.

Battery Backup for Power Failure Protection

This unit has a battery back up circuit that will keep the correct time and alarm settings in the event of a

temporary power interruption.

During power interruption, the back up battery will keep track of the time and store the alarm setting until

the power returns. The battery will not operate the LED clock display, radio, CD player or alarm function.

Install a 9-volt battery (type 6F22/006P), not included, into the BATTERY COMPARTMENT locates at the

bottom of the unit

Note:

We recommend an alkaline battery for longer usable life. Change batter 9 to 12 months for the best

result and to avoid possible battery leakage.

Select the Clock System (12/24 Hours)

1) Connect the AC Power Cord, LED Display will show “12:00” and

flash continuously.

2) Press TIME SET Button (9) for 3 seconds, LED Display will change to “24H”, then “0:00” and flash

3) Press and hold SKIP FORWARD >>|/HOUR BUTTON (10) to select the hour

4) Press and hold SKIP BACKWARD |<</MINUTE BUTTON (11) to select the minute

5) Press the TIME SET BUTTON (9) to store the time

Note: You may change the clock at any time after pressing the TIME SET BUTTON (9)

Select Alarm / Wake Up

You can set two different alarm times, ALARM 1 and ALARM 2, such that the alarm timer operates twice a

day (Dual alarm)

Alarm 1 operation

1) Set the FUNCTION SWITCH (13) to your desired wake up sound mode: Buzzer/CD/Radio

a. To wake up by radio, first tune in the desired station and adjust the volume

b. To wake up by CD first insert a CD in the CD compartment. In case there has no disc inside

you will be waked up by BUZZER automatically

2) Press ALARM 1 SET BUTTON (7), ALARM 1 INDICATOR (30) will light up while the LED DISPLAY

will blink

3) Press SKIP FORWARD >>| for set the hour, press SKIP BACKWARD |<< for set the minute

4) Press the Alarm 1 SET BUTTON (7) again to store the wake up time. LED Display will return to the

current time automatically

5) When the alarm time comes, ALARM 1 INDICATOR will blink while ON/OFF INDICATOR will light up

together with the wake up sound mode. (max. 60 minutes)

6) To switch off the alarm, press the ALARM 1 SET BUTTON (7) once.

7) To cancel Alarm 1 wake up setting, press ALARM 1 SET BUTTON (7) again. INDICATOR (30) will

disappear from the LED Display.

Alarm 2 operation all procedures the same as above for Alarm 1 operation.

Snooze Function

When alarming, press SNOOZE BUTTON (12) will temporary turn off the alarm for about 6 minutes.

Afterwards the alarm will resume again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Soundmaster URD820 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Soundmaster URD820

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info