Bedienungsanleitung Spartherm Ebios Fire - Quadra Inside Automatic I SL (Seite 16 von 28) (Englisch)

695788

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

GB 16

place the canister above the burner channel.

• Only ever connect the appliance to a professionally installed socket! The

power socket should be easy to access and should have a switch.

3.4.1 ASSEMBLY AND SETUP

1. Connect the small round low-voltage connector on the mains power unit

to the burner. The connector only fits the socket provided for it on the

underside. This socket is located at the same end of the burner as the

end where the hoses are connected. (Fig. 1)

2. Then the hoses supplied must be connected to the burner. Slide the

ends of the hoses firmly home over the connection grommets on the

underside of the burner until the stop. (Fig. 2)

3. Install the Quadra Inside Automatic I SL or II SL in the prefabricated

cutaway in the top plate or table plate. To do this, first lower the instal-

lation frame into the cutaway. Then install the burner in the instal-

lation frame until it locates against the screws in the edges. (Fig. 3)

Ensure that the hoses do not jam or damage the cable. Check to ensure

that the burner insert is horizontal

 Please check with a spirit level, but only when the appliance is cold, to

ensure that the burner is horizontal.

 The height adjustment screws must be accessible at all times.

 The height adjustment screws only have limited adjustment travel. If

no satisfactory levelling is possible in this way, construction measures

(e.g. rebasing of the installation frame) must be employed to improve

the installation situation.

4. Remove the sealing cover from the full ethanol canister. Next, screw

the filler adapter to the container. The hose ends with the metal suc-

tion grommet should be on the base of the canister to ensure that the

container can be emptied as completely as possible.

5. Connect the suction hoses to the filler adapters using quick-release

couplings. (Fig. 4)

3.4 COMMISSIONING

The ebios-fire-Quadra Inside Automatic I SL and II SL appliances are sup-

plied with empty delivery hoses to prevent any ethanol from escaping or

evaporating while in transit.

Ensure that the appliance is absolutely balanced. IMPORTANT!

Any failure to observe this point can cause the burner channel to

overflow.

Important information on start-up:

• The circular apertures down the longitudinal side of the burner housing

must remain free, and must not be plugged or narrowed. They act as

inlet air openings.

• Access to the height adjustment screws must be possible at all times.

• The adjustment path of the height adjustment screws is limited. If no

satisfactory levelling is possible in this way, construction measures (e.g.

rebasing of the installation frame) must be employed to improve the

installation situation.

• During first-time operation (commissioning), the hose is still empty. If

the ignition interval fails, it is possible that insufficient ethanol is left in

the burner channel.

• Ensure that the hoses do not bend excessively while being connected

and routed. Always avoid nip and chafing points and tensile stresses.

• Never secure the hoses to the outside of the burner housing. Instead,

leave them hanging free.

• Pull the quick-release couplings gently to check that they are firmly

connected to the filler adapters.

• Check all hose connections to ensure that the hose clamp is positioned

correctly. It must not be possible to pull the hoses off their grommets by

pulling them gently.

• The ethanol canister must always be set up under the burner. Never

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spartherm Ebios Fire - Quadra Inside Automatic I SL Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spartherm Ebios Fire - Quadra Inside Automatic I SL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info