Bedienungsanleitung Spartherm Passo S (Seite 32 von 53) (Englisch)

744245

Zoom out

Zoom in

Vorherige Seite

1/53

Nächste Seite

GB 32

4.2.2 HOURLY WOOD FEED QUANTITY

In order to avoid damage due to over-heating (discolouration of the steel,

deformation, etc.) and to guarantee optimum performance over the lifetime of

the appliance, ensure that the stove is fuelled in the proper manner. To prevent

any risk of over-heating, make sure that the maximum heating capacity is

never exceeded.

The proper amount of wood feed per hour can be found in the technical data.

The individual wood logs should be no more than 25 cm in circumference!

Please note: Larger feed quantities lead to overheating and damage to the

stove. Wood pellets (briquettes) have a higher heating capacity than hardwood.

The hourly feed rates are therefore to be keep 20% less than with wood logs.

In the event of damage caused by overheating (an excessively high hourly fee

rate), we shall decline all warranty claims.

4.3 CONTROLLING HEAT OUTPUT

Heat output is controlled by regulating the amount of fuel being added. Do not

try to slow down combustion excessively by reducing the flow of inlet air. When

heating with wood, this causes incomplete combustion and therefore wastes

fuel and causes unnecessary levels of environmental pollution because wood

releases gases even if no flames are produced. Incomplete combustion also

leads to increased soot accumulating on the pane! In addition, there is the

risk of a deflagration (explosive ignition of flue gases). Ensure that the firebox

door is always firmly closed to prevent combustion being accelerated by the

uncontrolled inflow of air. The performance of your stove is also dependent on

the draught in your chimney. This draught can be adversely affected by the cross

section of the chimney, or by environmental factors such as strong winds etc.

4.4 ROOM HEATING CAPACITY / INDOOR CLIMATE

The room heating capability used to be quoted in accordance with the DIN

18893 standard (most recent edition being August 1987) so is no longer a

meaningful indicator for modern houses constructed after 1990. As a com-

parison value, or for use on older housing stock that fails to comply with

the thermal insulation standard of 1977, the old indication of room heating

capability may still be of interest.

Precise descriptions of the terms 'favourable', 'less favourable' and 'unfa-

vourable' can be found in DIN 18893. The simplified description 'favourable'

applies to the case, where the room under consideration only has one external

wall and the remaining walls are adjacent to heated internal areas of the

building, "unfavourably" on the other hand is based on two exterior walls and

adjacent unheated rooms.

The values given refer to building fabrics that do not yet meet the require-

ments of the Heat Insulation Ordinance of 1977. They represent a simplifi-

cation which is valid for a room with a maximum size of up to 200 m3. Even

in room sizes larger than 200 m3, the DIN 18893 standard recommends a

calculation in accordance with DIN 4701. Nowadays, room heating capacity

estimates are made in accordance with TROL guidelines and more detailed

calculations in accordance with DIN 12831.

4.5 HEATING IN THE SHOULDER SEASONS/DURING

UNFAVOURABLE WEATHER CONDITIONS

In the transitional period, when outdoor temperatures are above about 15°C

or under unfavorable conditions (katabatic winds, etc.) disturbances in the

chimney draught during a sudden temperature may rise, so that the hot gases

are not completely removed. To prevent this, less fuel should be used and the

air supply should be open (). This allows more flame to develop, burns the fuel

more quickly and stabilises the draught. In order to prevent the build up of ash,

the fire should be stoked more frequently. Once the chimney draught has sta-

bilised, the supply air setting can be reduced. Once the chimney draught has

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spartherm Passo S Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spartherm Passo S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info