Bedienungsanleitung Spartherm Stovo S (Seite 26 von 53) (Englisch)

744234

Zoom out

Zoom in

Vorherige Seite

1/53

Nächste Seite

GB 26

activate the operating handle and the “cold hand”. The glove is

not fire-proof!

• The stove may only be operated with the fire door closed. The door should

be kept in a cold state is always closed. Only open the door for firing,

refueling and cleaning!

• The fireplace must never be modified! In particular, never insert any instal-

lation components into the combustion chamber, combustion air passages

or flue gas flue that have not expressly approved by Spartherm. Your

fireplace warranty and operating permit will be rendered invalid by any

fireplace modification that has not been approved.

• You may find that extractor hoods, ventilation equipment, etc. installed in

the same room (or linked space) as your fireplace or stove have a negative

effect on the operation of the Kaminofen (such as the release of smoke

into the room). These devices should not be used at the same time as your

fireplace or stove, without first ensuring that the necessary room heating

system precautions have been taken. („2.3.2.3 Room-air-independent“)

• In particular when operating several fireplaces in a single room or linked

space, ensure that sufficient air is available for complete combustion!

• This is a temporary fire area thus, longer continuous burning is not

achieved by piling up the fire repeatedly. Continuous burning without piling

up the fire in-between cannot be achieved even through withdrawal of

the combustion air and is also not permitted. A longer heating period is

achieved by repeatedly restoking the fire with suitable amounts of fuels.

• Only non-combustible materials must be placed in the lower compartment

of the cladding!

3.2 S-THERMATIK MINI

Supply voltage: 230 V / 24V (via

wall plug transformer)

Power consumption during operation approx. 10 VA

Power consumption in "Stand-by": ca. 6 VA

Safety class: III (safety extra-low voltage)

Degree of protection: IP 50

The S-Thermatik Mini combustion control is pre-set to your stove ex-factory.

Changes to the control parameters must only be carried out by an installer

/ stove fitter or the customer services. Please also follow the accompanying

service instructions!

3.2.1 COMMISSIONING THE S-THERMATIK MINI

In order to guarantee an optimum and trouble-free operation of the fire area,

the door contact switch must be kept free from dirt and grime.

Before opening the fire door, make sure that the selector switch points to

"automatic" when the combustion air control is switched on. In automatic

operation, the control is activated from the stand-by by opening the fire

door. Now the actuator motor runs the dosing facility for the combustion

air to the position "open". The logs are placed and ignited (see also "4.

Combustion"), the firebox door closed. Then, the combustion air is set and

controlled automatically via the actuator motor on the basis of the flue gas

temperature measured.

If the flue gas temperature is below 50°C after 10 minutes (after closing the

combustion chamber door), the combustion air is closed again by the control

without further signals. The air control lever moves to the left.

Heat-up errors: flue gas temperature is above 50°C but the pre-set minimum

temperature for starting the control is not reached: If the flue gas tempera-

ture then drops below 50°C, the combustion air supply is closed for another

15 minutes. An audible signal sounds. Reasons for a heat-up error could be

that not enough, too much, too large or fuel that is too moist has been added,

or the water heat exchanger pipes are blocked.

If there is a heat-up error and the flue gas temperature continues to increase,

the combustion air supply is throttled depending on the exhaust gas temper-

ature. Thus, the primary air (flows over the grate in the combustion chamber)

is closed first and then the secondary air is reduced (differential combus-

tion air setting). In doing so, the combustion air lever moves from the right

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spartherm Stovo S Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spartherm Stovo S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info