Bedienungsanleitung Spektrum SPM 18000 - DX18 (Seite 5 von 42) (Englisch)

606958

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

5SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

TRANSMITTER BATTERIES

• Read all safety precautions and literature prior to use of this product

• Never allow minors to charge battery packs

• Never drop charger or batteries

• Never attempt to charge damaged batteries

• Never attempt to charge a battery pack containing different types

of batteries

• Never charge a battery if the cable has been pinched or shorted

• Never allow batteries or battery packs to come into contact with

moisture at any time

• Never charge batteries in extremely hot or cold places (recom-

mended between 50–80 degrees F or 10–27 degrees C) or place

in direct sunlight

• Always disconnect the battery after charging, and let the charger

cool between charges

• Always inspect a new battery before charging

• Always terminate all processes and contact Horizon Hobby if the

product malfunctions

• Always keep batteries and charger away from any material that

could be affected by heat (such as ceramic and tile), as they can

get hot

• Always end the charging process if the charger or battery be-

comes hot to the touch or starts to change form (swell) during the

charge process

Battery and Charging Precautions and Warnings

Failure to exercise caution while using this product and comply with the following warnings could result in product malfunction,

electrical issues, excessive heat, FIRE, and ultimately injury and property damage.

Charging Your Transmitter

The DX18 has an internal charger designed to charge the

included 2-cell LiPo battery at a charge rate of 200mAh. The

charge port on the right side of the transmitter is not polarity-

dependent.

NOTICE: Never connect an external battery charger to your

DX18 transmitter. If you wish to charge the LiPo battery using a

LiPo charger, you must remove the battery from the transmitter

before charging.

The ﬁ rst time you charge the transmitter battery, the charge time

may be 12-15 hours. Always charge the transmitter on a heat

resistant surface.

1. Power off your transmitter.

2. Connect the power supply connector to the transmitter

charge port.

3. Connect the power supply to a power outlet using the appro-

priate adapter.

4. The blue LED on the front of the transmitter turns on during

charging and turns off when the battery is fully charged.

5. Disconnect the transmitter from the power supply once

charging is complete and disconnect the power supply from

the power outlet.

CAUTION: Never leave a charging battery unattended.

LED indicators

The blue LED indicates the transmitter battery is charging. The

orange LED indicates the transmitter is powered on and there is

radio transmission.

Battery Alarm

The System Settings Screen allows you to change the battery

type and low alarm settings. See “System Settings” for more

information.

• An alarm will sound when the battery reaches the low volt-

age limit (4.3V for NiMH, 6.4V for LiPo).

CAUTION: Never change the low voltage limit for LiPo

batteries from 6.4V. Doing so could over-discharge the

battery and damage both battery and transmitter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum SPM 18000 - DX18 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum SPM 18000 - DX18

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info