Bedienungsanleitung SpinMaster BATTLE TRACKER - Air Hogs (Seite 1 von 1) (Englisch)

585084

Zoom out

Zoom in

Vorherige Seite

1/1

Nächste Seite

Special Note to Adults:

- Adult supervision advised.

- Parental guidance is recommended when installing or replacing

batteries.

- Regularly examine the toy for damage to the controller, enclosure

and other parts. In the event of any damage, the toy must not be

used until the damage has been repaired.

- This toy must only be used with the attached controller.

- Under the environment with electrostatic discharge, the toy may

malfunction and require the user to reset the toy.

BECOMING FAMILIAR WITH YOUR CONTROLLER

TROUBLESHOOTING

PROBLEM

CAUSE SOLUTION

BATTERY SAFETY INFORMATION:

- Requires 4 x 1.5 V AA alkaline batteries (not included).

- Batteries are small objects.

- Replacement of batteries must be done by adults.

- Follow the polarity (+/-) diagram in the battery compartment.

- Promptly remove dead batteries from the toy.

- Dispose of used batteries properly.

- Remove batteries for prolonged storage.

- Only batteries of the same or equivalent type as recommended

are to be used.

- DO NOT incinerate used batteries.

- DO NOT dispose of batteries in fire, as batteries may explode

or leak.

- DO NOT mix old and new batteries or types of batteries

(i.e. alkaline/standard).

- DO NOT use rechargeable batteries.

- DO NOT recharge non-rechargeable batteries.

- DO NOT short-circuit the supply terminals.

Care and Maintenance:

- Turn off the toy when not in use.

- Always remove batteries from the toy when it is not being used

for a long period of time.

- Wipe the toy gently with a clean damp cloth.

- Keep the toy away from direct heat.

- Do not submerge the toy in water. This can damage the electronic

assemblies.

- New alkaline batteries are recommended for use in the toy to

obtain maximum performance.

- Users should keep strict accordance with the instruction manual

when operating the toy.

FCC Statement: This device complies with Part 15 of the FCC

rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that

may cause undesirable operation. This equipment has been

tested and found to comply with the limits for Class B digital

devices pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful

interference to radio communications. This equipment generates,

uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction, may cause harmful

interference to radio communication. However, there is no

guarantee that interference will not occur in a particular

installation. If this toy does cause interference to radio or

television reception (you can check this by turning the toy off and

on while listening for the interference), one or more of the

following measures may be useful: • Reorient or relocate the

receiving antenna • Increase the separation between the toy and

the radio or the TV • Consult the dealer or an experienced

TV-radio technician for help. NOTE: Changes, adjustments or

modifications to this unit, including but not limited to, replacement

of any transmitter component (crystal, semiconductor, etc.) could

result in a violation of FCC rules under part 15 and/or 95 and

must be expressly approved by Spin Master Ltd. or they could

void the user’s authority to operate the equipment.

2 3

CANADIAN Class B statement: This Class B digital apparatus complies with Canadian ICES-003.

YRS

ADVANCED

SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO,

ON M5V 1B6 CANADA

Customer Care: 1-800-622-8339 Fax: 416-364-8005

Email: customercare@spinmaster.com

Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,

Williamsville, NY 14221, USA

Imported into EU by:

SPIN MASTER INTERNATIONAL, S.A.R.L.,

16 AVENUE PASTEUR, L-2310, LUXEMBOURG

www.spinmaster.com

Air Hogs

This product conforms to safety requirements of ASTM F-963, EN-71 & CHPA.

• Please retain this information for future reference. • Please remove all packaging

materials before giving to children. • An adult should periodically check this toy to

ensure no damage or hazards exist, if so, remove from use. • Children should be

supervised during play. • Keep addresses and phone numbers for future

reference. • The item inside this package may vary from the photographs and/or

illustrations. MADE IN CHINA.

20051716 REV 0

T44417_0001_20051716_GEN_IS_R1

CONTENTS LIST AND PARTS IDENTIFICATION

Battle Tracker™ Controller 16 x Missiles Instruction GuideRadar Screen

BATTLE TRACKER™

HOW TO INSTALL YOUR BATTERIES

PREPARING BATTLE TRACKER™ FOR PLAY

HOW TO USE THE CONTROLLER

1. Open the battery door with a screwdriver (pic.1). 2. If used batteries are present, remove these batteries from the unit by pulling up

on one end of each battery. DO NOT remove or install batteries using sharp or metal tools. 3. Install new batteries as shown in the

polarity diagram (+/-) inside the battery compartment (pic.2). 4. Replace battery door securely (pic.3). 5. Check your local laws and

regulations for correct recycling and/or battery disposal.

pic.1pic.1 pic.2pic.2 pic.3pic.3

INSTRUCTION

GUIDE

Front

a WARNING:

CHOKING HAZARD – Small parts.

Not for Children under 3 years.

STRANGULATION HAZARD –

This product contains a long cord.

Back

Radar Screen

Missile Pod

Missiles

Base

Controller

MANUAL/OFF/AUTO*

Switch

Cable Storage

a WARNING:

Do not aim at eyes or face.

a CAUTION: Do not use

projectiles other than those

provided with this toy.

Requires 4 x 1.5 V AAA batteries (not included). Batteries must be

recycled or disposed of properly. When this product has reached the

end of its useful life it should not be disposed of with other household

waste. The Waste Electrical and Electronic Equipment Regulations

require it to be separately collected so that it can be treated using the best

available recovery and recycling techniques. This will minimize the impact on the

environment and human health from soil and water contamination by any

hazardous substances, decrease the resources required to make new products

and avoid using up landfill space. Please do your part by keeping this product

out of the municipal waste stream! The “wheelie bin” symbol means that it

should be collected as “waste electrical and electronic equipment”. You can

return an old product to your retailer when you buy a similar new one. For other

options, please contact your local council.

a Warning:

CHOKING HAZARD –

Small Parts.

Left Button

Fire Button

Down Button

Up Button

Demo Button

Right Button

Attaching Radar Screen

Align post on radar screen with

hole in top of Battle Tracker™

and carefully push post into

hole until it fits snugly.

Remove controller carefully from back

of unit, then turn unit to manual (ON)

and wait for announcement.

To spin right,

press...

Loading Missiles

Align hole in back of missile with pin in missile pod and

slide missile onto pin until it fits snugly. Repeat for each

pin until all missiles are loaded in each pod.

To spin left,

press...

HOW TO USE THE CONTROLLER cont’d...

To rotate down,

press...

To rotate up,

press...

To fire missile

from right pod press

fire button again.

Repeat until all

missiles are fired.

To fire missile

from left

pod press fire

button.

When finished playing

store cable in controller,

then align hole in back

of controller with pin in

unit housing and snap

controller into place.

Turn unit off.

*When switch is set in

AUTO mode Battle Tracker™

automatically tracks

the Saw Blade™ helicopter.

Unit does not move.

Unit does not respond to controller.

Unit stops during play.

Missile did not fire.

Manual/Off/Auto switch is set to off.

Weak battery.

Manual/Off/Auto switch is set to Auto or Off.

Weak battery.

12 missiles are fired.

Missile installed incorrectly.

Not using Spin Master’s™ missile.

Launcher empty.

In Auto mode: Turret does not ‘lock’ the

target.

Set switch to Manual or Auto.

Replace batteries.

Set switch to Manual.

Replace batteries.

Set switch Off and reload missles.

Ensure missile pushed completely onto

launcher.

Replace with Spin Master’s™ missile.

Re-load launchers.

Missiles will fire automatically once target

is locked.

TROUBLESHOOTING cont’d

PROBLEM

CAUSE SOLUTION

For further questions and problems, please visit our website www.airhogs.com.

NOTE: If normal function of the product is disturbed or

interrupted, strong electro-magnetic interference may be causing

the issue. To reset product, turn it completely off, then turn it back

on. If normal operation does not resume, move the product to

another location and try again. To ensure normal performance,

change the batteries, as low batteries may not allow full function.

Unit won’t track helicopter.

Unit did not shut down after

being shot.

Incorrect helicopter being used.

Helicopter out of range.

No output signal from helicopter’s controller.

Manual/Off/Auto switch is set to Off or Manual.

Radar dish not properly installed.

Shot missed.

Radar is in protect mode during launching of

foam dart.

Radar dish not hit hard enough.

Use only the Saw Blade™ helicopter

provided with the unit.

Must be within 15 ft. of helicopter.

Turn the controller ON and apply throttle.

Set switch to Auto.

Ensure radar dish is firmly positioned in its

socket.

Hit radar only, nowhere else.

Hit it again.

SpinMaster BATTLE TRACKER - Air Hogs Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info