Bedienungsanleitung Spirit ET188 (Seite 14 von 17) (Englisch)

584040

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

ET188

TREADBELT TRACKING ADJUSTMENT:

The performance of your treadmill is dependent on the frame running on a reasonably level

surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt

adjustment may be necessary.

The treadmill is designed to keep the tread-belt reasonably centered while in use. It is normal

for some belts to drift near one side while the belt is running with no one on it. After a few

minutes of use, the tread-belt should have a tendency to center itself. If, during use, the belt

continues to move toward one side, adjustments are necessary.

TO SET TREADBELT TRACKING:

A 6 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments from the

left side only. Set belt speed at

approximately 2 to 3 mph. A small

adjustment can make a dramatic difference.

Turn the bolt only a 1/4 turn and wait a few

minutes for the belt to adjust itself.

Continue to make 1/4 rotation turns until

the belt stabilizes in the center of the

running deck. The belt may require

periodic tracking adjustment depending on

use and walking/running characteristics.

Some users will affect tracking differently.

Expect to make adjustments as required to center the tread-belt. Adjustments will become less

of a maintenance concern as the belt is used. Proper belt tracking is an owner responsibility

common with all treadmills.

ATTENTION:

DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /

TENSION ADJUSTMENTS IS NOT COVERED UNDER THE SPIRIT WARRANTY.

MAINTENANCE MODE:

If you want to set the Speed and Distance to Metric or if there is a problem with the speed and

you would like to perform the calibration procedure, use the Maintenance Mode. To enter

Maintenance Mode press, and hold for 5 seconds, the Start, Stop and Mode keys while

installing the safety key.

• The dot matrix display will now be showing the word SET

• The Speed window will show a number for the roller size, press the up and/or Down key

to adjust the roller size. The roller size for the ET188 is 1.8

• The Speed window will also display the setting for M (miles) or Km (Kilometers). Press

the Stop key to change between M and Km.

• To run the calibration procedure, press the Start key.

o The display will show a number for the lowest speed setting (for miles the

number should be 0.5). Adjust the low speed setting and press Start.

o The display will show a number for the top speed setting (for Miles it should be

8.0). Adjust the top speed setting and press Start to begin calibration.

o The belt will start automatically and will adjust speeds between low and high. Be

careful because the belt will change speeds without warning. When the

calibration is finished the display will return to the start-up screen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spirit ET188 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info