583961
9
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
5
Elliptical T
rainer
XE295
1. Locate the Console Mast (12) and Console Mast Cover (41) and slide the Cover onto the Mast as far as it will
go. Make sure the Console Mast Cover (41) is facing the correct way.
2. At the top opening of the Main Frame (1), there is a Computer Cable (31) tied to a twist tie wire. Feed the
twist tie wire and Computer Cable (31) into the bottom of the Console Mast (12) and out of the opening at
the top.
3. Install the Console Mast (12) into the receiving bracket on the top of the Main Frame (1). Note: there is one bolt
already installed in the receiving bracket that will engage with the slot at the bottom of the Console Mast. This needs
to be tightened last, after the three other console mast bolts.
4. Place a Split Washer (96) onto the Hex Head Bolt (60) and hand tighten through the left side of the console
mast. Place a Curved Washer (84) onto each Hex Head Bolt (103) and thread both into the front of the
console mast tube. Fasten these front bolts as tight as possible with the wrench (106). Next rmly tighten the
two left side bolts with the same wrench. NOTE: The Computer Cable (31) runs through the Console Mast
(12). Be careful not to pinch this cable during this procedure because it may affect the electrical functions of the
console.
5. Connect the two Hand pulse cables (36), Resistance cable (124), and Computer Cable (31) to the back of the
console (30). Do not force the connectors; they will only t one way and are different sizes to prevent
confusion. Store the excessive cable in the Console Mast tube (12).
6. Attach the Console (30) to the bracket of the console mast tube with four Phillips Head Screws (66). Tighten
the screws with the Phillips Head Screw Driver (108).
HARDWARE
STEP 1: Console Mast
#96.3/8” x 2T
Split Washer
(1 pc)
#84.3/8” x 23 x 1.5T
Curved Washer
(2 pcs)
#66.M5 x 10mm
Phillips Head Screw
(4 pcs)
#103.3/8” x 3/4”
Hex Head Bolt
(2 pcs)
#60.3/8” x 2-1/4”
Hex Head Bolt
(1 pc)
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Spirit XE295 2011-2012 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info