Bedienungsanleitung Spirit XT385 2011-2012 (Seite 16 von 19) (Englisch)

583954

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Treadmill

XT385

Treadmill

XT385

The treadmill is designed so that the tread-belt remains reasonably centered while in use. It is

normal for some belts to drift near one side while in use, depending on a user’s gait and if they

favor one leg. But if during use the belt continues to move toward one side, adjustments are

necessary.

SETTING TREAD-BELT TRACKING

An 6mm Allen wrench is provided for this adjustment. Make tracking adjustments on the left side

bolt. Set belt speed at 3 mph. Be aware that a small adjustment can make a dramatic difference

which may not be apparent right away. If the belt

is too close to the left side, then turn the bolt

only a 1/4 turn to the right (clockwise) and wait

a few minutes for the belt to adjust itself.

Continue to make 1/4 turns until the belt

stabilizes in the center of the running deck.

If the belt is too close to the right side, turn the

bolt counter-clockwise. The belt may require

periodic tracking adjustment depending on use

and walking/running characteristics. Some users may affect tracking differently. Expect to make

adjustments as required to center the tread-belt. Adjustments will become less of a maintenance

concern as the belt is used. Proper belt tracking is an owner responsibility common with all

treadmills.

ATTENTION

Damage to the running belt resulting from improper tracking / tension adjustments is not

covered under the Spirit Fitness warranty.

Treadbelt Tracking Adjustment

Do not lubricate with other than Spirit Fitness approved lubricant.

Your treadmill comes with one tube of lubricant and extra tubes can

be ordered directly from Spirit Fitness or your authorized Spirit Fitness

dealer.

Keeping the deck lubricated at the recommended intervals ensures

the longest life possible for your treadmill. If the lubricant dries out, the

friction between the belt and deck rises and places undue stress on

the drive motor, drive belt and electronic motor control board, which

could result in catastrophic failure of these expensive components. Failure to lubricate the deck at regular

intervals may void the warranty.

The belt & deck come pre-lubricated and subsequent lubrication should be performed every 180 hours

of use. The console has a built in lubrication reminder indicator that lights every 180 hours of use.

Use the lubricant to lubricate the deck beneath the belt. If you can reach under the belt approximately

6” on each side, use the following procedure: Unplug the electrical cord. At the middle of the deck, lift up

on the belt and reach under with the tube of lubricant. Squirt most of the lubricant on the deck surface.

Repeat the process on the opposite side. Plug the electrical cord back into the outlet and walk on the belt

at a moderate speed for ve minutes.

If unable to perform the above procedure, it will be necessary to loosen the walking belt. Using the 6

mm Allen wrench supplied, loosen the two rear roller adjustment bolts -- located in the rear end caps –

enough to get your hand under the belt (5 –10 turns). Make sure to loosen both bolts the same amount

of turns and also remember how many turns, because when nished you will need to tighten the bolts

back to the point they were before.

Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the whole

tube of lubricant onto the deck surface about 18 inches from the motor cover. Squeeze out the contents

of the tube across the deck (parallel to the motor cover) in about a one-foot line, like toothpaste on a

toothbrush. The one-foot line should be in the middle of the deck at approximately equal distance from

both side edges of the belt. You want the lubricant to be applied about the spot that your feet would hit

the belt as you are walking. This should be about 18 inches from the motor cover, but you may want to

walk on the treadmill before loosening the belt to note where your feet land on the belt. If you mostly use

the treadmill for running, the spot where your feet land may be different from walking.

Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when you

loosened them. Run the treadmill at about 3 mph without walking on it for about a minute or two to

make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt

tracking instructions to remedy. Now the deck is lubricated and you should walk, not run, on the treadmill

immediately for at least 5 minutes to ensure the lubricant is evenly distributed.

Belt/Deck Lubrication Procedure

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spirit XT385 2011-2012 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info