Z100. / Z500 / Z900
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when the
strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the treadmill
is positioned flat on the ground, in the orientation it would be in if you were using the treadmill. Do
not turn the treadmill up on it’s side while removing the shipping strap. This could cause the
treadmill’s folding mechanism to spring open. If the end of the Velcro strap (that you need to grab to
remove it) happens to be under the treadmill deck, reach under the deck to grab it, but do not tilt the
treadmill up to gain access to the strap end.
ASSEMBLY PACK CHECK LIST (Z100 / Z500)
(12 pcs) 5/16 x1/2 Button Head Socket Screw
(3 pcs) M3 x 18 m/m Phillips Head Screw (Z500 only)
(1pc) Safety Key
(1 pc) Deck / Belt Lubricant
(1 pc) Combination M5 Allen Wrench & Phillips Head Screwdriver
(1 pc) M6 Allen Wrench
Assembly ( Z100 / Z500 )
STEP 1
Remove all parts from the carton.
STEP 2
Connect Computer Cable (Lower) with Computer Cable (Middle).
STEP 3
Hand tighten Right and Left Uprights into the Frame Base with 8 pcs of 5/16 x 1/2
Button Head Socket Screws, by using the Combination M5 Allen Wrench & Phillips Head
Screwdriver
STEP 4
Connect Computer Cable (Middle) with Computer cable (Upper).
Connect Speed Adjustment Switch W/Cable with Speed Cable (Upper).
And Connect Incline Adjustment Switch W/Cable with Incline Cable (Upper).
STEP 5
Install the Console Support into the Right and Left Handrails with 4 pcs of 5/16 x 1/2
Button Head Socket Screws by using the Combination M5 Allen Wrench & Screwdriver.
STEP 6
Connect the Computer Cable of Fan Assembly with Console.
Install the Fan Assembly onto Console with 3 pcs of M3 x 18 m/m Phillips Head Screws
by the Combination M5 Allen Wrench & Phillips Head Screwdriver. (Z500 only)
PLEASE LOCK DOWN ALL HARDWARE AFTER THE ACCESSSORIES HAVE BEEN
ASSEMBLED.
