35
Lubrication
After running for a period of time, the treadmill must be configured with special cymene silicone oil
for lubrication.
Suggestion:
Do not lubricate more than what you need to. Remember: regular and
reasonable lubrication is to improve the lifespan of your treadmill.
Lubrication method
If its neccessary to lubricate the treatmill (Please pay attention to the intervals) do it like this:
1. Please loosen the walking bolt, you can archive this in turning the screws at the end of the
treatmill.
2. If the walking beld is loosen you kan pull it up at one side and put a stripe of oil
3. on the frame, do the same at the other side.
4. Now tighten the belt again and activate the treatmill in the lowest possible speed for 5 minutes.
After this you can use the treatmill again.
Running belt tension adjustment
You may need to adjust the treadmill according to your personal needs. But after running for a period
of time, due to personal weight, the belt tension may change from default setup. If you realize that
the belt is slippery that may be caused by loose tension, then you need to adjust the running belt
and roller. Please do not adjust too tight that may bring too much pressure on the motor which would
damage the motor, running belt and roller.
Running belt far to the right side adjustment
At the operating state, pressing the “+” and “ - ” or the rise “SHORTCUT” key can adjust the grade of
the treadmill.
• Main frame is not being placed on a flat surface.
• Users are not running in the middle of the belt.
• Forced deviation.
After a few minutes no-load rotation, the deviation can not be automatically restored. If not
recovered,you may adjust it with the 6mm hex key in the Tool Kit, turn it clockwise for 90 degrees.
If deviate to the left, then adjust the screw on the left side clockwise or the screw on the right side
anticlockwise. If deviate to the right, then adjust the screw on the right side clockwise.
MAINTENANCE
