Bedienungsanleitung Stadler Form Anna Big (Seite 9 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

807160

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

• Stadler Form refuses all liability for loss or damage which arises as a result

of failure to follow these operating instructions.

• The appliance is only to be used in the home for the purposes described

in these instructions. Unauthorised use and technical modifications to the

appliance can lead to danger to life and health.

• Never submerge the unit in water (danger of short circuiting).

• Never run a defective unit (e.g. supply cord).

• Never touch energized parts.

• Only connect the cable to alternating current. Observe the voltage infor-

mation given on the appliance. Do not use extension cords.

• The heater must not be located directly below a socket-outlet.

• Do not open the appliance (repairs only by service agents).

• Do not run the power cord over sharp edges and make sure that it does

not get trapped. Do not pull the plug from the socket with wet hands or by

holding on to the power cord.

• Do not place the appliance near a heat source. Do not subject the power

cord to direct heat (such as a heated hotplate, open flames, hot iron sole

plates or heaters for example). Protect power cords from oil.

• Please make sure that the used socket remains accessible.

• Do not run the heater on an uneven or soft surface.

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the

thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer.

• WARNING: In order to avoid overheating, do not cover the air inlet or air

outlet – fire hazard!

• Do not use the heater in small rooms (below 4 m2 in size), in explosive envi-

ronment, or for drying laundry.

• Do not touch the front part of the appliance, it might reach hot tempera-

ture.

• Use the heater only under supervision.

• Do not insert any object and/or finger into the openings of the heater.

• To extinguish burning appliances only use fire blankets.

Setting up / operation

Note: Make sure that there is always sufficient space between the appli-

ance and the wall or other large objects (> 50 cm). The air flow must not

be blocked by objects of any kind. If Anna big is set up in a bathroom, keep

a safety distance of at least 100 cm to showers, bathtubs, water faucets,

washbasins, etc.

1. Having set up Anna big in the desired position connect the cable (1) to the

household supply socket.

2. First, push the main switch for power supply (4) on the back of the ap-

pliance.

3. Switch on the appliance by pressing the On/Off button (6). The target

temperature appears on the display.

4. The target temperature can be changed from 0 °C (cooling mode) to

35 °C or maximum «Hi» over the right control panel (8) «Temperature».

The heating mode is active from 1 ° – 35 °C & «Hi». The digit flashes in

configuration mode. Pushing the «+» button increases the target tem-

•If the supply cord is damaged, it must be replaced by the manufacturer,

or its service agent, or a qualified person in order to avoid a hazard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stadler Form Anna Big Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info