Bedienungsanleitung Stadler Form EVA (Seite 10 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

669364

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

2. After around one minute the results can be seen on the test strip.

Some of the green fields change colour into pink. The water hardness is shown

by how many boxes turn pink. Example: If three are pink, then the water hard-

ness is >14 °dH.

Number of

pink boxes

Water

hardness

Degree of

hardness

(°dH)

Cartridge will last for

(with 4 liter/day)

Days Liter

0/1 Soft

From 4

°dH

90 days approx. 360 L

2 Moderately

hard

From 7

°dH

45 days approx. 180 L

3 Hard

From 14

°dH

30 days approx. 120 L

4 Very hard

From 21

°dH

15 days approx. 60 L

With a water hardness above 21 °dH, we can no longer recommend the use

of an ultrasonic humidifier. We recommend that you use an evaporative

humidifier to increase the humidity in your house (e.g. an Oskar humidifier

made by Stadler Form: www.stadlerform.com/Oskar).

Note: Do not operate Eva with decalcified water out of a decalcification

system that uses the principle of an ion exchanger (salt is added to the wa-

ter). The salt contained in the water may lead to white dust accumulation

around the appliance. To minimize this risk, you can operate Eva using a mix

of distilled and tap water. The mixing ratio should be 50:50.

Attention: Please do not operate the unit using pure distilled water as the

water level indicator will not work correctly. However, Eva may be operated

from a drinking water filter system (e.g. Brita). Should you be unsure about

the quality or composition of the water in your area, contact the caretaker or

your drinking water provider.

Setting up / operation

1. Put Eva in the desired location on a flat surface. The mist reaches a

height of up to 1.4 m thanks to the high-performance humidification (out-

put level 5, warm mode on). This makes it possible to place Eva directly

on the floor. Connect the power cord (1) to a suitable socket.

2. Take the Remote Sensor

(2), the stand (3) and the two batteries out of

the packaging. Open the battery compartment (4) on the underside of

the Remote Sensor

(2) by turning the lid anticlockwise. Insert the two

batteries into the battery compartment (4), as shown on page 4, and

close the lid again. Now place the Remote Sensor

(2) on the stand (3).

3. On the one hand, the Remote Sensor

(2) is a humidity sensor and

guarantees precise humidification by its external position. On the other

hand, the Remote Sensor

(2) also serves as a remote control. Position

the humidity sensor Remote Sensor

(2) in the centre of the room on a

table or a sideboard with an optimal distance from Eva between 3 – 5 m.

The Remote Sensor

should be positioned centrally in the room so that

the room air can flow past the sensor (5) as freely as possible. If this is

not possible, we recommend positioning the Remote Sensor

with a

minimum distance of 30 cm from the wall and a minimum distance of 2 m

from windows and ventilation openings.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stadler Form EVA Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info