8. The swing function can be activated by pressing one of the «Swing
Mode» buttons (11) on the left-hand and right-hand side of the hous-
ing. The appliance now swings at an angle of approx. 90° to ensure a
wide distribution of heat. Press the «Swing Mode» button again if the
appliance is to remain at a certain angle. If the target temperature is
reached, the appliance remains at the angle it was in at the point the tar-
get temperature was reached until the room temperature drops below
the target temperature and the appliance switches on again.
9. Switch off the appliance by pressing the On/Off button (6). The ventila-
tor remains switched on for three minutes at the lowest level to cool
down the heating element. The appliance saves the temperature input
and the heat output level even if the appliance is switched off.
10. The remote control (13) is in the compartment for remote control (12) on
the back of the appliance. The temperature and the heat output level
can be changed by pressing the appropriate buttons. The remote control
operates via infrared - to this end, point the remote control at the front
of the appliance (the sensor is at the very top on the front of the appli-
ance). The battery compartment (14) is on the back of the remote control
(type CR2032). This can be opened by pushing the cover downwards.
11. Protection against overheating: the appliance is equipped with over-
heating protection which switches off the appliance in the event of a
technical fault or improper use (the ventilator continues to run for some
time at the lowest level to cool down the appliance). Should this occur,
rectify the fault or cease the improper use (e.g. 50 cm space around the
appliance, do not cover the appliance, set the appliance up in an upright
position). Once the appliance has cooled down it can be put back into
service.
12. The temperature indicator can be changed from Celsius to Fahrenheit
and vice versa by pressing the «Auto Mode» button (10) for five seconds.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (1) from the socket.
Attention: Never immerse the device in water (danger of short circuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Make sure that the air inlet and outlet are cleaned regularly to prevent
the build-up of dust. Clean the air outlet (18) with a dry brush or vacuum
cleaner. The air inlet grid (17) is fitted with an air filter (15) which can be
removed and cleaned with a damp cloth. Remove the filter by pulling out
the flap at the bottom using the recessed grip.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.
