Bedienungsanleitung Stadler Form Peter Little (Seite 6 von 40) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

807168

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

• Do not run the power cord over sharp edges and make sure that it does

not get trapped.

• Do not pull the plug from the socket with wet hands or by holding on to

the power cord.

• Do not use the appliance in immediate vicinity of a bath tub, a shower or a

swimming pool (observe a minimum distance of 3 m). Place the appliance

such that a person in the bath tub cannot touch the appliance.

• Do not place the appliance near a heat source. Do not subject the power

cord to direct heat (such as a heated hotplate, open flames, hot iron sole

plates or heaters for example). Protect power cords from oil.

• See to it that the appliance is properly positioned to ensure a high stabil-

ity during its operation and make sure that no one can trip over the power

cord.

• The appliance is not splash-proof.

• For indoor use only.

• Do not store the appliance outdoors.

• Store the appliance in a dry place inaccessible to children (pack the ap-

pliance).

• Prior to any maintenance, cleaning and after each use, switch off the ap-

pliance and unplug the mains cable from the socket.

• Repairs to electrical appliances must only be carried out by a qualified

electrical technician.

• Only use the adapter provided by the manufacturer.

Setting up / operation

1. Place Peter little in the desired location on a flat surface. Connect the

power adapter (1) to the appliance (2) and insert the adapter into a suit-

able mains socket.

2. Switch on the appliance by pressing the On/Off button (3). The appli-

ance gives an audible signal when a setting is changed via the control

panel (4).

3. Press the button for the selection of the speed level (5) to change the

fan speed (levels 1–4). Pressing once increases the speed by one level.

If you would like to increase the speed by another level, press again.

4. Activate swing mode by pressing the swing mode button (6). The appli-

ance now swings at an angle of approx. 70° to ensure optimum distribu-

tion of cooling air throughout the room. Press the swing mode button (6)

again if the appliance is to remain at a certain angle.

5. Press the button for the selection of “Natural Breeze” mode (7) for natu-

ral wind conditions. The blue LED beneath the button (7) will now light

up. This mode provides an even more pleasant cooling effect, simulat-

ing a natural breeze. The fan speed of this breeze automatically varies

depending on the selected speed level.

6. Switch off the appliance by pressing the on/off button (3).

Cleaning

Prior to any maintenance, cleaning and after each use, switch off the appli-

ance and unplug the mains cable (1) from the socket.

Attention: Never submerge the appliance in water (danger of short-circuit).

• For external cleaning, rub with a damp cloth and then dry thoroughly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stadler Form Peter Little Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info