Bedienungsanleitung Standard Horizon CPF390i - GPS Chart Plotter-Fish Finder (Seite 32 von 168) (Englisch)

603482

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

CP390i and CPF390i Page 33

3.1.0 Power On, Off and ShuttlePoint Knob operation

1. Press and hold [PWR] until the display shows the Start-Up page (see the following

picture). To turn Off, press and hold [PWR] until the display turns Off.

GPS Chart Plotter

CPF390i

Software V16.30 00R

Figure 3.1.0 - Example of Start-Up page on CPF390i

2. When the power is first turned on two pages the start-up page and the Caution pages are

briefly shown before the GPS Status page.

WARNING-LIMITATIONS ON USE

This product, including the C-MAP by Jeppesen charts, is intended to be used only as

an aid to navigation. It should facilitate use of official government charts, not replace

them. Only Official Government Charts and Notices to Mariners contain all the current

information needed for safe navigation. This product’s features cannot be relied on as

complete or accurate and may vary depending on location. It is the captain’s

responsibility to use official government charts, notices to mariners, caution, sound

judgment and proper navigational skills when operating their boat using this product.

This product supports C-MAP by Jeppesen electronic charts. Their use is subject to a

separate Jeppesen Data License Agreement which can also be found at

www.jeppesen.com, where users may also register to receive regular product safety

information.

The built- in C-MAP by Jeppesen background charts of this product contain a limited

version of chart datasets only for general awareness.

By pressing ENTER, you confirm that you:

1. acknowledge the above warning and accept the limitations of this product and the

C-MAP by Jeppesen charts

2. have read the documentation for this product, including its notes, and the Jeppesen

Data License Agreement, and agree to be bound by the terms of the Jeppesen Data

License Agreement.

WARNING

This product contains a limited set of built-in C-

MAP by Jeppesen Charts.

Contact your dealer or Jeppesen for upgrade

options. Register with Jeppesen to receive

regular product safety information.

Press ENTER to proceed.

Figure 3.1.0a - Caution pages

NOTE

The Caution page on the left is shown only if the data C-CARD is over one year old.

IMPORTANT:

The built-in C-MAP by Jeppesen charts are out-of-date, and may be

unsafe for navigation, which could place you and others at risk. You

are encouraged to contact your local dealer or Jeppesen to update the

built-in charts. Register with Jeppesen

(www.jeppesen.com) for real-time product updates and safety notices.

Press ENTER to proceed .

Figure 3.1.0b - Built-In Charts warning pages

3. When the GPS Chart Plotter is first turned on it will take some time for the GPS to acquire

a fix of your position. Look closely at the GPS Status page and you will see satellites and

relative signal strengths of each satellite. After a fix is received the GPS Chart Plotter

will automatically switch to the Chart Page with the ship icon centered on the screen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Standard Horizon CPF390i - GPS Chart Plotter-Fish Finder Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info