G
B
23
5.4 Fitting the air lter (ref. 1)
Remove the transportation stop with a screwdriver or
5.5
Replacing the oil sealing plug (ref. 14)
opening with a screwdriver and insert the supplied oil
5.6 Voltage
5.6.1 Connection of the mains plug (electrical
information for the BS plug)
Important!
● This product is double insulated and therefore
does not require a connection to earth.
● The 3 pin plug must comply to BS1363/A.
● Fuse must comply to BS1362.
If for any reason the 13 amp plug fitted to this product
requires replacement it must be wired in accordance
with the following instruction:
Do not connect the brown (live) or blue (neutral) to
the earth pin marked ‘E’ on the 3 pin plug.
Connect the Blue wire to the terminal marked Neutral
by the cord grip and that the wires are not trapped
If in doubt consult a qualified electrician
any part of the casing unless qualified to do so; this unit
Warning!
For your protection if this product is to be used outdoors
it should not be exposed to rain or used in damp
Note: If the mains cable requires replacing it must be
replaced with an identical one and fitted by a
5.7 On/Off switch (8)
5.8 Adjusting the pressure (Fig. 1)
● You can adjust the pressure on the pressure gauge
●
5.9 Setting the pressure switch
5.9.1 D 210/8/6 - D 210/8/24 - D 210/8/50
: 6 bar
5.9.2
D 240/10/xx - D(L) 250/10/xx - D 260/10/xx -
DV2 400/10/xx - DV4 400/10/xx
: 10 bar
6. CLEANING AND MAINTENANCE
Warning!
Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Warning!
Wait until the compressor has completely cooled
down. Risk of burns!
Warning!
Always depressurize the tank before carrying out
any cleaning and maintenance work.
6.1 Cleaning
● Keep the safety devices free of dirt and dust as far