622142
8
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
8
ENGLISH
(Original instructions)
9
ENGLISH
(Original instructions)
u In particular clean the air vents (1) after every use with a
cloth and brush.
u Remove stubborn dirt with high pressure air (max. 3 bar).
Note: Do not use chemical, alkaline, abrasive or other
aggressive detergents or disinfectants to clean this product as
they might be harmful to its surfaces.
u Check for worn or damaged parts. Replace worn parts
as necessary or contact an authorised service centre for
repair before using the product again.
Maintenance
u Before and after each use, check the product and
accessories (or attachments) for wear and damage. If
required, exchange them for new ones as described in this
instruction manual. Observe the technical requirements.
Repair
This product does not contain any parts that can be repaired
by the consumer. Contact an authorised service centre or a
similarly qualied person to have it checked and repaired.
Storage
u Switch the product off and disconnect it from the power
supply.
u Clean the product as described above.
u Store the product and its accessories in a dark, dry, frost-
free, well-ventilated place.
u Always store the product in a place that is inaccessible to
children. The ideal storage temperature is between 10°C
and 30°C.
u We recommend using the original package for storage or
covering the product with a suitable cloth or enclosure to
protect it against dust.
Transportation
u Switch the product off and disconnect it from the power
supply.
u Attach transportation guards, if applicable.
u Always carry the product by its handles (2).
u Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
u Secure the product to prevent it from slipping or falling
over.
Troubleshooting
Suspected malfunctions are often due to causes that the
users can x themselves. Therefore check the product using
this section. In most cases the problem can be solved quickly.
Problem Possible Cause Solution
Product does not start Not connected to power
supply
Connect to power
supply
Power cord or plug is
defective
Check by a specialist
electrician
Other electrical defect to
the product
Check by a specialist
electrician
Product does not
reach full power
Extension cord not suitable
for operation with this
product
Use a proper
extension cord
Power source (e.g.
generator) has too low
voltage
Connect to another
power source
Air vents are blocked Clean the air vents
Unsatisfactory
result
Stirrer is worn Replace with new
one
Stirrer not suitable for
material to be mixed
Use proper stirrer
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Stanley FME190 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info