Bedienungsanleitung Stanley SFMCBLB76 (Seite 11 von 116) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720481

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

ENGLISH

tube assembly. The tube assembly must be attached to the

housing beforeuse.

TO ASSEMBLE BLOWER TUBES

1. Align the upper tube

6

to the blower and the lower tube

7

to the upper tube as shown in Fig.C.

2. Push the upper tube firmly onto the blower, until the lock

engages and an audible click isheard.

3. Then push the lower tube firmly into the upper tube, until

the lock engages and an audible click isheard.

4. Pull on the tubes to ensure they are securely inplace.

NOTE: To remove either tube, insert a screwdriver into the

unlocking hole on the housing. Lift the tab inside and pull

tubeout.

OPERATION

Instructions for Use



WARNING: Always observe the safety instructions and

applicableregulations.



WARNING: To reduce the risk of serious personal

injury, turn tool off and disconnect battery pack

before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can causeinjury.

Proper Hand Position (Fig.A, D)



WARNING: To reduce the risk of serious personal injury,

ALWAYS use proper hand position asshown.



WARNING: To reduce the risk of serious personal

injury, ALWAYS hold securely in anticipation of a

suddenreaction.

Hold the handle

3

with one hand. as shown in figureF.

Switching On (Fig.A)



CAUTION: Do not point unit discharge at self

orbystanders.



CAUTION: Always wear safety glasses. Wear a filter mask

if the operation is dusty. Use of gloves, long pants and

substantial footwear is recommended. Keep long hair and

loose clothing away from openings and movingparts.

1. To turn the blower on, depress the variable speed trigger

1

2. Release the trigger to turn the bloweroff.

• To lock the blower on, pull back on the cruise control

lever

2

. The blower runs at higher speeds as the lever is

moved further. The cruise control lever can also be pulled

back to start the blower without needing to first depress the

variable speedtrigger.

• To turn the blower off when using the speed lock lever, push

the lever toward the front of theblower.

• Hold the blower with one hand as shown in FigureD and

sweep from side to side with the tube assembly several

inches above the hard surface. Slowly advance keeping the

accumulated pile of debris in front ofyou.

MAINTENANCE

Your STANLEYFATMAX power tool has been designed

to operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends upon

proper tool care and regularcleaning.



WARNING: To reduce the risk of serious personal

injury, turn tool off and disconnect battery pack

before making any adjustments or removing/

installing attachments or accessories. An accidental

start-up can causeinjury.

The charger and battery pack are notserviceable.

Lubrication

Your power tool requires no additionallubrication.

Cleaning



WARNING: Blow dirt and dust out of the main housing

with dry air as often as dirt is seen collecting in and around

the air vents. Wear approved eye protection and approved

dust mask when performing thisprocedure.



WARNING: Never use solvents or other harsh chemicals

for cleaning the non-metallic parts of the tool. These

chemicals may weaken the materials used in these parts.

Use a cloth dampened only with water and mild soap.

Never let any liquid get inside the tool; never immerse any

part of the tool into aliquid.

Optional Accessories



WARNING: Since accessories, other than those offered by

STANLEYFATMAX, have not been tested with this product,

use of such accessories with this tool could be hazardous.

To reduce the risk of injury, only STANLEYFATMAX

recommended accessories should be used with

thisproduct.

Consult your dealer for further information on the

appropriateaccessories.

Protecting the Environment

Separate collection. Products and batteries marked

with this symbol must not be disposed of with normal

householdwaste.

Products and batteries contain materials that can

be recovered or recycled reducing the demand for raw

materials. Please recycle electrical products and batteries

according to local provisions. Further information is available at

www.2helpU.com.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails to

produce sufficient power on jobs which were easily done before.

At the end of its technical life, discard it with due care for our

environment:

• Run the battery pack down completely, then remove it from

thetool.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SFMCBLB76 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info