Bedienungsanleitung Stanley SFMCPH845 (Seite 9 von 156) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

720496

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

ENGLISH

• Keep children, animals and bystanders at a safe distance

away from Pole Hedge Trimmer. Only Pole Hedge Trimmer user

should be in workarea.

• Grip Pole Hedge Trimmer securely - one hand on the foam

gripper, the other on the mainhandle.

• Keep finger off trigger until ready touse.

• Before starting Pole Hedge Trimmer, make sure blades are not

touchinganything.

• Keep all parts of body away from blades when Pole Hedge

Trimmer isrunning.

• Carry Pole Hedge Trimmer from one place to another

- with battery removed

- by holding pole at balance point

- with blades to rear

• Do not operate in poorlighting.

• During operation, rest periodically and change working

positions to reducefatigue.

• Keep firm footing and balance. Do not overreach.

Overreaching can result in loss of balance or exposure to

sharpsurfaces.

• Do not, under any circumstance, use any attachment or

accessory on this product, which was not provided with the

product, or identified as appropriate for use with this product

in this InstructionManual.

Do Not Operate Pole Hedge Trimmer

• While under the influence of alcohol, medication, or drugs in

rain or in damp or wet areas

• Where highly flammable liquids or gases are present

• If Pole Hedge Trimmer is damaged, adjusted wrong, or not fully

and securely assembled

• If trigger does not turn Pole Hedge Trimmer on and off. Blades

must stop moving when you release trigger. Have faulty switch

replaced by authorized service center. SeeRepairs.

• While in a hurry

• While in tree or on a ladder

• While on aerial booms, buckets or platforms

• During high wind or storming weather

General Safety Rules



WARNING: Shock Hazard. To protect yourself from

electrocution, do not operate within 10 feet (3 m) of

overhead electrical lines. Consult local regulations for safe

distances from overhead electric power lines and ensure

that the operating position is safe and secure before

operating the extended reach hedge trimmer. Failure to do

this could result in severe personalinjury.

• Keep the handles dry, clean, and free ofoil.

• Make sure cutting blades have stopped before setting

unitdown.



DANGER: RISK OF CUT. Keep hands away from blades.

Keep both hands on handles when Pole Hedge Trimmer

ison.

• DO NOT ATTEMPT to remove cut material or hold material

to be cut when blades are moving. Remove battery when

clearing jammed material from blades. Do not grasp the

exposed cutting blades or cutting edges when picking up or

holding the Pole HedgeTrimmer.



CAUTION: Blades coast after turnoff.

• DON’T FORCE POLE HEDGE TRIMMER - It will do the job

better and with less likelihood of a risk of injury at the rate for

which it wasdesigned.

• DISCONNECT BATTERY from the Pole Hedge Trimmer when

not in use or when servicing orcleaning.

• STORE IDLE POLE HEDGE TRIMMER INDOORS - When not

in use, Pole Hedge Trimmer should be stored indoors in a dry

and high or locked-up place out of reach ofchildren.

• MAINTAIN POLE HEDGE TRIMMER WITH CARE - Keep

cutting blades sharp and clean for best performance and to

reduce the risk of injury. Keep handles dry, clean and free from

oil andgrease.

• CHECK DAMAGED PARTS - Before further use of the Pole

Hedge Trimmer, a guard or other part that is damaged should

be carefully checked to determine that it will operate properly

and perform its intended function. Check for alignment of

moving parts, binding of moving parts, breakage of parts,

mounting and any other condition that may affect its

operation. A guard or other part that is damaged should be

properly repaired or replaced by an authorized service center

unless otherwise indicated elsewhere in thismanual.

Service

• Tool service must be performed only by qualified repair

personnel. Service or maintenance performed by unqualified

personnel could result in a risk of injury. SeeRepairs.

• When servicing a tool, use only identical replacement

parts. Follow instructions in the Maintenance section of

this manual. Use of unauthorized parts or failure to follow

Maintenance Instructions may create a risk of electric shock

orinjury.

Specific Safety Rules

• Hold tool by insulated gripping surfaces when

performing an operation where the cutting tool may

contact hidden wiring. Contact with a “live” wire will make

exposed metal parts of the tool “live” and shock theoperator.

Residual Risks

Additional residual risks may arise when using the tool which

may not be included in the enclosed safety warnings. These risks

can arise from misuse, prolonged useetc.

Even with the application of the relevant safety regulations and

the implementation of safety devices, certain residual risks can

not be avoided. These include:

• Injuries caused by touching any rotating/movingparts.

• Injuries caused when changing any parts, blades

oraccessories.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SFMCPH845 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info