Bedienungsanleitung Stanley SGC-13000N-T (Seite 6 von 92) (Deutsch, Englisch, Dänisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

720567

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

Machine use and care

Never pick up or carry a machine while the

engine is running.

Do not force the machine. Use the correct

machine for your application. The correct

machine will do the job better and safer at the

rate for which it was designed.

Do not change the engine governor settings

or over-speed the engine. The governor controls

the maximum safe operating speed of the engine.

Do not run the engine at a high speed when

you are not pounding.

Do not put hands or feet near rotating parts.

Avoid contact with hot fuel, oil, exhaust fumes

and hot surfaces. Do not touch the engine or

muffler. These parts get extremely hot from

operation. They remain hot for a short time

after you turn off the unit. Allow the engine

to cool before doing maintenance or making

adjustments.

If the machine should start to make an unusual GB

noise or vibration, immediately shut off the

engine, disconnect the spark plug wire, and

check for the cause. Unusual noise or vibration

is generally warning of trouble.

Use only attachments and accessories

approved by the manufacturer. Failure to do

so can result in personal injury.

Maintain the machine. Check for misalignment

or binding of moving parts, breakage of parts

and any other condition that may affect the

machine’s operation. If damaged, have the

machine repaired before use. Many accidents

are caused by poorly maintained equipment.

Keep the engine and muffler free of grass,

leaves, excessive grease or carbon build up to

reduce the chance of a fire hazard.

Never douse or squirt the unit with water or

any other liquid. Keep handles dry, clean and

free from debris. Clean after each use.

Observe proper disposal laws and regulations

for gas, oil, etc. to protect the environment.

Store idle machine out of the reach of children

and do not allow persons unfamiliar with

the machine or these instructions to operate

it. Machine is dangerous in the hands of

untrained users.

Service

Before cleaning, repair, inspecting, or

adjusting, shut off the engine and make

certain all moving parts have stopped. Always

make sure the engine’s switch is in its “OFF”

position. Disconnect the spark plug wire, and

keep the wire away from the plug to prevent

accidental starting.

Have your machine serviced by a qualified

repair personnel using only identical

replacement parts. This will ensure that the

safety of the machine maintained.

Specific Safety Rules

To avoid injury, keep hands, fingers and feet

away from the base plate. Grip the handle of

the plate compactor firmly with both hands.

If both hands are holding the handle and your

feet are clear of the compactor base, your

hands, fingers and feet can not be injured by

the compactor base.

Always operate the machine from behind, never

pass or stand in front of the machine when the

engine is running.

Never place tools or any other item under the

plate compactor.

If the unit strikes a foreign object, stop the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SGC-13000N-T Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info