Bedienungsanleitung Stanley SPT-163-560 (Seite 7 von 199) (Deutsch, Englisch, Französisch, Italienisch)

720578

Zoom out

Zoom in

Vorherige Seite

1/199

Nächste Seite

Always check overhead and side clearances

carefully before operation. Always be aware of

traffic when operating along streets or curbs.

Thoroughly inspect the area to be worked.

Keep the working area clean and free of toys,

doormats, newspapers, sleds, boards, wires

and other foreign objects, which could be

tripped over or thrown by the auger/impeller.

Check for weak spots on docks, ramps or

floors.

Plan your snow-throwing pattern to avoid

discharge toward people or areas where

property damage can occur.

Do not operate near drop-offs, ditches, or

embankments. Machine can suddenly turn

over if a wheel is over the edge of a cliff or

ditch, or if an edge caves in.

Keep all bystanders, children, and pets at least

23m (75 feet) away. If you are approached,

stop the unit immediately.

Use a grounded three-wire extension cord and

receptacle for all machines with electric start

engines.

Check clutch and brake operation frequently.

Adjust and service as required. All motion of

drive wheels and auger/impeller must stop

quickly when control levers are released.

Let engine and machine adjust to outdoor

temperature before starting to clear snow.

Stay alert for hidden hazards or traffic.

Do not overload machine capacity by

attempting to clear snow at too fast of a rate.

Do not throw snow any higher than necessary.

Adjust auger housing height to clear gravel

or crushed rock surfaces. Exercise extreme

caution when operating.

Exercise caution to avoid slipping or falling,

especially when operating in reverse. Never

operate machine at high transport speeds

on slippery surfaces. Always look down and

behind before and while backing.

Do not operate on steep slopes. Do not

clear snow across the face of slopes. Keep

all movement on slopes slow and gradual.

Do not make sudden changes in speed or

direction. Use a slow speed to avoid stops or

shifts on slopes. Avoid starting or stopping

on a slope. Do not park machine on a slope

unless absolutely necessary. When parking on

a slope, always block the wheels.

Disengage power to the auger/impeller when

transporting or not in use.

Disengage all control levers and stop engine

before you leave the operating position

(behind the handles). Wait until the auger/

impeller comes to a complete stop before

unclogging the chute assembly, making any

adjustments, or inspections.

Hand contact with the rotating impeller inside

the discharge chute is the most common

cause of injury associated with snow throwers.

Do not unclog chute assembly while engine

is running. Shut off engine and remain behind

handles until all moving parts have stopped

before unclogging. Never put your hand in

the discharge or collector openings. Always

use the clean-out tool provided to unclog the

discharge opening.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SPT-163-560 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info