Bedienungsanleitung Stanley SPT-182-570 (Seite 6 von 233) (Deutsch, Englisch, Französisch, Italienisch, Finnisch)

720579

Zoom out

Zoom in

Vorherige Seite

1/233

Nächste Seite

fueling is complete. Do not use a nozzle lockopen

device.

Never over fill fuel tank. Fill tank to no more

than 12.5mm (1/2”) below the bottom of the

filler neck to provide space for expansion as

the heat of the engine and/or sun cause fuel

to expand.

Replace all fuel tank and container caps

securely and wipe up spilled fuel. Never

operate the unit without the fuel cap securely

in place.

Avoid creating a source of ignition for spilled

fuel. If fuel is spilled, do not attempt to start

the engine but move the machine away

from the area of spillage and avoid creating

any source of ignition until fuel vapors have

dissipated. Serious personal injury can occur

when fuel is pilled on yourself or your clothes

which can ignite. Wash your skin and change

clothes immediately.

Store fuel in containers specifically designed

and approved for this purpose.

Never fill containers inside a vehicle or on a

truck or trailer bed with a plastic liner. Always

place containers on the ground away from

your vehicle before filling.

Store fuel in a cool, well-ventilated area.

Safely away from sparks, open flames or other

sources of ignition.

Never store fuel or machine with fuel in the

tank inside a building where fumes may

reach a spark, open flame, or other sources

of ignition, such as a water heater, furnace,

clothes dryer and the like. Allow the engine to

cool before storing in any enclosure.

Machine use and care

Never pick up or carry a machine while the

engine is running.

Do not force the machine. Use the correct

machine for your application. The correct

machine will do the job better and safer at the

rate for which it was designed.

Do not change the engine governor settings

or over-speed the engine. The governor

controls the maximum safe operating speed

of the engine.

Do not put hands or feet near rotating parts.

Avoid contact with hot fuel, oil, exhaust fumes

and hot surfaces. Do not touch the engine or

muffler. These parts get extremely hot from

operation. They remain hot for a short time

after you turn off the unit. Allow the engine

to cool before doing maintenance or making

adjustments.

After striking a foreign object, stop the

engine, remove the wire from the spark

plug, thoroughly inspect the machine for

any damage, and repair the damage before

restarting and operating the machine.

If the machine should start to make an unusual

noise or vibration, immediately shut off the

engine, disconnect the spark plug wire, and

check for the cause. Unusual noise or vibration

is generally warning of trouble.

Use only attachments and accessories

approved by the manufacturer. Failure to do

so can result in personal injury.

Maintain the machine. Check for misalignment

or binding of moving parts, breakage of parts

and any other condition that may affect the

machine’s operation. If damaged, have the

machine repaired before use. Many accidents

are caused by poorly maintained equipment.

Keep the engine and muffler free of grass,

leaves, excessive grease or carbon build up to

reduce the chance of a fire hazard.

Never douse or squirt the unit with water or

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley SPT-182-570 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info