Bedienungsanleitung Stanley ST-45-KFA-E (Seite 77 von 85) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch, Polnisch)

720270

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

1030 Brussels, Belgium

NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO A POWER SOURCE

Safety Information

This is a parafin, direct-fired, forced air heater. It is primarily

intended for use for temporary heating of buildings under

construction, alteration or repair. This appliance produces small

amounts of carbon monoxide. WARNING! Risk of indoor air

pollution! Use this heater only in well ventilated areas! Provide at

least a 2,800 sq cm opening of outside air for every 29,3 kw/hr or

100,000 BTU/hr of heater rating. Provide a larger opening if more

heaters are being used.

Risk of burns / fire / explosion! NEVER

use fuel such as gasoline, benzene, alcohol,

white gas, camp stove fuel, paint thinners,

or other oil compounds in this heater (THESE ARE VOLATILE

FUELS THAT CAN CAUSE A FIRE OR EXPLOSION).

Minimum clearance from Combustibles:

ST-45-/ 70T-/ 125T-/ 175T-/ 215T-KFA-E

Top 4 ft / 1.22m

Sides 4 ft / 1.22m

Front 10 ft / 3.05m

- NEVER refill the heater’s fuel tank while heater is operating or

still hot. This heater is EXTREMELY HOT while in operation.

- Keep all combustible materials away from this heater.

- NEVER block air inlet (rear) or air outlet (front) of heater.

- NEVER use duct work in front or at rear of heater.

- NEVER move or handle heater while still hot.

- NEVER transport heater with fuel in its tank.

- If equipped with a thermostat, the heater may start at any time.

- ALWAYS locate heater on a stable and level surface.

- ALWAYS keep children and animals away from heater.

- Bulk fuel storage should be a minimum of 7.6m (25 ft). from

heaters, torches, portable generators, or other sources of

ignition.

- ALWAYS unplug the heater when not in use.

- Not for use in homes or recreational vehicles.

- Never use this heater in living or sleeping areas.

- NEVER use heater where flam mable vapors may be present.

- Use only the electrical power (voltage and frequency) specified

on the model plate of the heater.

- ALWAYS install the heater so that it is not directly exposed to

water spray, rain, dripping water, or wind.

- NEVER store fuel in direct sunlight, indoors, or near a source

of heat.

- NEVER use fuel that has been stored from one season to the

next. Fuel deteriorates over time. OLD FUEL WILL NOT BURN

PROPERLY IN THIS HEATER.

Assembly

MODELS ST-45/70T-KFA-E

- Tools required: Medium phillips screw driver.

1. Align the holes in the upper housing with the 2 holes in the

handle.

2. Insert and tighten screws securely with screw driver.

3. Insert tabs on cordwrap into slots in shell support, lining up the

holes on the cordwrap with those on the side cover.

4. Insert and tighten screws securely with screw driver.

MODELS ST-125T/175T/215T-KFA-E

- Tools required: Medium phillips screw driver, 8mm open end

or adjustable wrench, needle nose pliers.

1. Slide axle through holes in Wheel Support Frame.

2. Slide wheels on to each axle.

3. Attach nut to axle and tighten.

4. Place heater on the assembled frame, making sure that the air

inlet end is by the wheels, and the mounting holes on the tank

flange of the heater align with holes in frame.

5. Take the front handle and align the mounting holes with the

corresponding holes in the tank flange/wheel frame. Slide a

screw (A) through the holes and loosely attach a nut. Repeat

for the other 3 holes, then fully tighten all 4 screws and nuts.

6. Repeat this process with the rear handle.

NOTE: The cord wrap is an optional feature that is not available

on all models.

WARNING

Carbon Monoxide poisoning may lead to

death!

DANGER

NEVER REFUEL THIS HEATER WHILE

IT IS HOT OR OPERATING. FIRE OR

EXPLOSION COULD RESULT.

WARNING

NEVER FILL THE FUEL TANK INDOORS.

ALWAYS FILL THE TANK OUTDOORS.

BE SURE THAT THE HEATER IS ON LEVEL GROUND WHEN

FUELING, AND NEVER OVERFILL THE FUEL TANK.

CAUTION

Figure 1. Handle Assembly

Do not operate this heater until you have

read, and thoroughly understand these

safety and operating instructions. Failure to comply with the

precautions and instructions provided with this heater can result

in death, serious bodily injury, property loss or damage from the

hazards of fire, soot production, explosion, burns, asphyxiation

or carbon monoxide poisoning. Only persons who can read and

understand these instructions should use or service this heater.

Retain this manual for your reference.

WARNING

Fire, burn, inhalation, and explosion

hazard. Keep combustibles a safe distance

away from the heater as recommended by these instructions.

Never use the heater in spaces which contain products such

as gasoline, solvents, paint thinners, dust particles, volatile or

airborne combustibles, or any unknown chemicals. This is an

unvented portable heater. It uses air (oxygen) from the area in

which it is used. Adequate combustion and ventilation air must

be provided.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stanley ST-45-KFA-E Seite 77

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info