720390

Stanley SXUP750XCE Seite 11

11
Zoom out
Zoom in
Vorherige Seite
1/242
Nächste Seite
10 11
(Translation of the original instructions)
© 2017 English
(Translation of the original instructions)
© 2017 English
EN
EN
WARRANTY
The warranties relating to the appliances described in this manual are conditional on compliance with all the recommendations it contains, especially those
relating to use, installation and operation.
We grant a warranty of 24 months (12 months for professional sales) from the date of purchase for the product described, covering defects in material or
workmanship in accordance with current legislation. Requests for service under warranty must be accompanied by the original proof of purchase.
The warranty does not cover the costs of dismantling and installing the appliance concerned in the place of use, travel costs to and from the place of use for
repair staff, or transport costs.
Claims arising from incorrect installation or operation, unsuitable conditions of use, negligence, commercial use or inappropriate repair attempts are not covered
by the warranty and no responsibility is accepted for them; normal wear and tear is also excluded.
The resulting costs, and especially inspection and transport costs, will be charged to the sender and/or the appliance's operator. This also applies, in particular,
when a warranty request is submitted but the appliance is found to be operating perfectly with no defects, or the problem is not due to defects in materials or
workmanship.
Before return to the user, every product undergoes strict technical inspection. Repairs under warranty must only be performed by one of our Service Centres or
an authorised repair workshop. Attempted repairs by the customer or unauthorised third parties during the warranty period will result in the loss of all warranty
entitlement.
Cutting off the power plug and/or shortening the power cable result in loss of warranty entitlement.
Work done by us under warranty does not extend the duration of the warranty, or give rise to a new warranty period for the parts replaced or repaired.
All further entitlement, including the right to discounts, changes or compensation, or consequent damage of any kind, is excluded.
In the event of malfunction, contact the point of sale where the product was purchased, showing proof of purchase.
11 TROUBLESHOOTING
Problems Possible causes Remedies
The appliance does not pump water
because the motor is not running
1. Mains voltage too low.
1. Check that mains power is present and that the plug (A12) is
firmly connected.
2. Plug (A12) not properly connected. 2. Firmly connect the plug (A12).
3. Residual current device tripped.
3. Reset the residual current device. If the device trips again,
consult an electrician.
4. Impeller jammed. 4. Free the impeller from possible obstructions.
5. Motor or capacitor damaged. 5. Notify the dealer.
The appliance does not pump water
even though the motor is running
1. Suction strainer (A1) fouled. 1. Clean the suction strainer (A1).
2. Check valve jammed (if installed). 2. Clean or replace the valve (if installed).
3. Air bubble in pump body (A4).
3. Tilt the appliance under water to allow the air to escape from the
pump body (A4).
The appliance only delivers a small
amount of water
1. Suction strainer (A1) partially fouled. 1. Clean the suction strainer (A1).
2. Hose obstructed. 2. Remove the obstruction.
3. Delivery hose too small. 3. Use hoses of at least ø25 mm (1”).
4. Water discharge point too high in relation to appliance. 4. Remember that excessive head will reduce the flow rate.
Uneven operation
1. Solids are obstructing free rotation of the impeller. 1. Remove the dirt!
2. Liquid too hot.
2. The maximum temperature of the pumped liquid must not
exceed 35°C.
3. Electrical voltage outside tolerance range.
3. Connect the appliance to an electrical system which meets the
requirements stated on the nameplate.
4. Motor faulty. 4. Notify the dealer.
Water leaking from pump body (A4)
1. Water leaks from the bleeder hole (A7) between the top and
bottom parts.
1. No action needed; the bleeder hole is a technical necessity.
… 11 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Stanley SXUP750XCE wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info