Bedienungsanleitung StarTrac 7060 Series - Spinner (Seite 27 von 30) (Englisch)

619112

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

 





  

This section provides the procedures to maintain the Spinner

indoor cycling bikes in serviceable condition. Differences between models are noted

where applicable.

MOVING AND LEVELING

To move the bike to a new location:

Lift the bike from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the bike from one location to another.

To level the bike:

Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven floor surfaces.

PREVENTIVE MAINTENANCE

Perform regular scheduled preventive maintenance procedures to maintain your Spinner

indoor cycling bike in serviceable condition.

Note: Star Trac strongly recommends replacing the pedals after two years of use.

AINTENA

NCE

OOLS

Tools required for service and maintenance of your Spinner

indoor cycling bike are listed below.

Tool Purpose

Pedal Wrench, 15mm* Remove and install pedals.

Shimano-compatible Bottom Bracket Tool* Remove, install and adjust the bottom bracket. (Spinner

Cotterless Crank Puller* Remove crank.

Metric Allen Wrench Set and Metric Socket, 2mm ~ 6mm Install and adjust leg bolts, chain tensioner, brake pad and crank bolts.

Crescent (adjustable) Wrench Adjust chain tension.

Torque Wrench Adjust crank arm.

* Available at local bike or fitness-related stores.

AILY

AINTENANCE

The service life of your Spinner

indoor cycling bike will be determined by how consistently you perform the daily maintenance procedures. Dry the

Spinner

indoor cycling bike after each use to remove sweat and moisture. It is best to use a liquid non-abrasive cleaner and water solution.

Wipe Down / Cleaning

To prevent the build-up of rust and other forms of corrosion, wipe down the bike at the end of each day (or preferably at the end of each class). Raise

all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration can settle. Give particular attention to

the following areas:

o Handlebar

o Seat / adjustable slide for the seat

o Flywheel

o Back leg assembly

o Chain guard

o Brake knob and bolt assembly

o Pop-pins

o Leveling feet

NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the bike.

NOTE: Release all tension from the resistance knob after each use to allow for perspiration to evaporate. If bikes are used in a class setting, the

instructor may direct class participants to release all tension for the resistance knob after each use.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

StarTrac 7060 Series - Spinner Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info