Bedienungsanleitung Steel Cucine GP6B-4 (Seite 12 von 52) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch)

651795

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

Installing the top

The appliance is designed to be embedded into

heat-resistant pieces of furniture.

The walls of the pieces of furniture must resist a

temperature of 75°C besides the room one.

The equipment must not be installed near

inflammable materials, such as curtains, cloths,etc.

Make a hole in the top of the piece of furniture,

with the dimensions indicated in fig.3, at a distance

of at least 50 mm from the appliance border to the

adjacent walls.

MODEL L (mm) P (mm)

GP6B-4 SS 560 480

GP7B-5 SS 720 480

GP9B-5 SS 860 480

Any possible wall unit over the cook-top must be

placed at a distance of at least 760 mm from the

top.

It is advisable to isolate the appliance from the

piece of furniture below with a separator, leaving a

depression space of at least 10 mm (fig. 4).

If the hob is going to be installed on the top of an

oven, precautions must be taken to guarantee an

installation in accordance with current accident

prevention standards. Pay particular attention to

the position of the electric cable and gas pipe: they

must not touch any hot parts of the oven.

Moreover, if the hob is going to be installed on

the top of a built in oven without forced cooling

ventilation, proper air vents must be installed to

guarantee an adequate ventilation, with the lower

air entering with a cross section of at least 200cm

and the higher air exiting with a cross section of at

least 60 cm

Fastening the top

Every cook-top is equipped with a special washer.

A set of hooks is also supplied for mounting the

cook-top.

For the installation proceed as follows:

- Remove the racks and burners from the top.

- Turn the appliance upside down and lay the

washer S along the external border (fig. 5).

- Introduce and place the cook-top in the hole made

in the piece of furniture, then block it with the V

screws of the fastening hooks G (fig.6).

Installation room

This appliance is not provided with a device for

exhausting the products of combustion.

Regarding room ventilation rules where appliance

is installed make reference to the legislation, in

conformity with the local regulations.

FOR THE U.K. ONLY

The room containing this hotplate should have an

air supply in accordance with BS 5440: Part 2:

1989.

- All rooms require an openable window, or

equivalent and some rooms will require a

permanent vent a well.

- For room volumes up to 5 m

an air vent of 100cm

is required.

- For room volumes between 5 m

and 10 m

an air

vent of 50 cm

is required.

- If the room is greater than 5 m

and has a door

that opens directly to the outside, then no air vent

is required.

If there are other fuel burning appliances in the

same room BS 5440: Part 2:1989 should be

consulted to determine the air vent requirements.

IMPORTANT NOTICE:

THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL

EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.

THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE,

ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Steel Cucine GP6B-4 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info