Bedienungsanleitung Steel Cucine PARTY (Seite 75 von 220) (Deutsch, Englisch, Französisch, Italienisch)

651782

Zoom out

Zoom in

Vorherige Seite

1/220

Nächste Seite

Instructions for the installer

3.8 Gas adjustments

The injectors not supplied with the appliance should be requested from the Service Centre.

If the cooking appliance is set up for a different type of gas than that available, its injectors must be

replaced, the minimum flow regulated and the rubber-holder changed. In order to replace the

injectors in the cooking hob, it is necessary to carry out the following operations:

For cooktops, the Data Label is located on the underside of the appliance. A duplicate label is

supplied to adhere in an accessible area adjacent to the appliance. For cookers, the label is

situated in the appliance drawer. This appliance is suitable for Natural Gas and Propane; ensure

that the available gas supply matches the Data Label.

If the cooking appliance is set up for a different type of gas than that available, its injectors must be

replaced, the minimum flow regulated and the rubber-holder changed. In order to replace the

injectors in the cooking hob, it is necessary to carry out the following operations:

• remove the pan supports;

• remove the burners and burner caps (Fig. A);

• take out the injector (Fig. B) and replace it with one

suitable for the new type of gas (see "G

ENERAL

INJECTORS TABLE

" on page 76-77);

• replace the gas label (on the rear of the appliance) with

the new one provided with the injectors kit;

• refit all parts by following the disassembly instructions in

reverse order and taking care to position the burner cap

correctly on the burner.

3.8.1 Minimum flow of valved cooking hob taps

• Switch on the burner and turn the control

knob towards the minimum flow position ;

• remove the knob;

• using a screwdriver, adjust the internal screw

Z until the correct low flame is obtained;

• refit the knob.

•

Unscrew the adjustment screw Z to increase the flow, or tighten it to reduce the flow.

•

The adjustment is correct when the low flame measures approximately 3 or 4 mm.

•

For butane/propane, the adjustment screw should be tightened all the way.

•

When changing quickly from maximum to minimum flow and vice versa make sure that the

flame does not go out.

3.9 Connecting to LPG

Gas may only be connected to a gas installation, whether bottle supplied or other.

When converting from Natural Gas to Propane ensure that the NG regulator is removed and

replaced with the Test Point Assembly. A gas regulator suitable for a supply pressure of 2.75kPa

should be part of the gas tank supply and should be adjusted with the Wok burner operating at

maximum. Replace the old data plate with one which is suitable for the type of gas for which the

appliance has been regulated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Steel Cucine PARTY Seite 75

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info