Bedienungsanleitung Steinel HF 360 UP (Seite 10 von 44) (Alle Sprachen)

592483

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Functions

Contact-free switching

Move your hand in front of

the sensor unit at a dis-

tance of max. 5 cm and the

connected light will switch

on.The procedure is equally

simple when switching off.

Orientation light

The Sensor Switch

NF 50 UP is equipped with

a red LED. This serves as

an orientation light in the

dark, so that the switch is

easier to find.

Note:

Parallel switching or ex-

change of an existing two-

way circuit is not possible.

(only for NF 50 UP)

Technical specifications

IR 180 UP: NF 50 UP:HF 360 UP:

Note for IR 180 UP:

The installation position

should be at least 1 m from

a light, since heat radiation

may trigger the system.

Installation procedure:

1. Pull the mains lead out

of the flush box and strip

the insulation from the

individual leads.

Connecting the supply

lead (refer to Ill. on

page 5)

The mains lead consists of

a 3 phase cable.

L = phase conductor

(usually black or

brown)

N = neutral conductor

(usually blue)

L‘ = phase conductor

(usually black or

brown)

If in doubt, the cable must

be identified with a voltage

tester. Switch off the current

again. Phases (L) and (L‘)

in addition to the neutral

conductor (N) are connec-

ted to the terminal block. A

protective-earth conductor

is not required.

Important: Reversing the

connections may result in

damage to the unit.

2. Push the basic elem-

ent  into the flush box

 and arrange horizon-

tally. Take care that the

cables are not pinched.

Tighten both screws on

the expansion claw until

the basic element is firm-

ly seated or screw with

socket fixing screws on

the support ring.

3. Apply the cover frame 

and surround  and

carefully mount the sen-

sor unit  without tilting.

4. Once the mains connec-

tion has been made, the

sensor switch can be

operated (refer to Func-

tions section).

Only IR 180 UP and

HF 360 UP:

The adjustment controls for

the functions are concealed

behind the folding design

shade. Push in the catch on

the sensor unit with a screw-

driver and fold the design

shade forwards.

Note:

Parallel switching of

IR 180 UP and HF 360 UP

is possible. Nevertheless, a

neutral lead must be pres-

ent on each flush box. The

max. output to be switched

does not increase as a re-

sult.

* Installation above a door

(IR 180 UP / HF 360 UP / NF 50 UP)

Dimensions:

Output:

Connection:

Contact gap:

Installation height:

Sensor technology:

Transmission output:

Angle of coverage:

Reach:

Twilight setting:

Time setting:

Permanent light:

Permanent light OFF:

Orientation light:

(H x W x D) 80 x 80 x 55 mm

max. 1000 W (ohmic load, e.g. filament bulb)

max. 500 VA (uncompensated, inductive, cos ϕ = 0.5

e.g. fluorescent lamps )

230 V, 50 Hz

3-lead connection (L, L’, N)

µ, contact clearance of less than 1.2 mm between the

contacts when unit is switched off.

approx. 1.1 + 2.2 m*

Infrared sensor

180° with 90° angle

of aperture

max. 8 m

2 - 2000 lux

10 sec. - 30 min.

switchable (4 h)

switchable

approx. 1.1 + 2.2 m*

5.8 Ghz

High frequency

approx. 1 mW

360° with 140° angle

of aperture

1 - 8 m

continously adjustable

2 - 2000 lux

10 sec. - 30 min.

switchable (4 h)

switchable

approx. 1.1 m

5.8 Ghz

High frequency

approx. 1 mW

approx. 5 cm

red LED

Installation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Steinel HF 360 UP Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info