Operation
Technical Specifications
In order to switch on the
light without a heat source
in the detection zone,
switch the indoor power
switch momentarily. This
will activate the light for
the period selected.
Weather can affect the
function of the sensor light
fixture. Strong gusts of
wind, snow, rain or hail may
cause switching errors,
because the unit cannot
distinguish the sudden
change of temperature.
The Fresnel lens should be
periodically wiped clean
with a damp cloth if it gets
dirty.
Do not use any cleaning
materials.
Line voltage: 220 – 240 V/50 – 60 Hz
Power output: max. 60 watts
Power consumption: 1.3 W
Detection angle of sensor: 360° all-round lens
(with 120° angle of aperture)
Swivelling range of sensor: 2 x 40° in every direction
ON time, adjustable: 10 sec. to 15 min.
Lighting threshold, adjustable: 2 – 2,000 lux
Brightness setting: 0 – 50% (Watt-o-matic)
Sensor range (dependent on sensor setting,
ambient temperature, and direction of approach)
From the front: 12 m (40 ’)
From the side: 16 m (20 ’)
Type of enclosure: IP 44, splashproof
Temperature ranging from: - 20° C to + 50° C
GB
11
Function
Once the sensor light fixture
has been wired up and
fastened to the wall support,
it can be switched on.
a. Lighting controller
(threshold)
The desired light threshold
can be adjusted continu-
ously from about 2 lux to
2,000 lux. The adjusting
screw turned clockwise all
the way equals daytime
operation at approx. 2,000
lux; counter clockwise all
the way equals nighttime
operation at approx. 2 lux.
(The unit is shipped with a
factory setting for daytime
operation.) When adjusting
the sensor light fixture
detection zone and for a
performance test during
daylight, the adjusting
screw must be turned
clockwise all the way.
b. Switch-off delay
(time setting)
The period for which the
fixture should light up can
be adjusted continuously,
from about 10 seconds to
15 minutes. The adjusting
screw turned clockwise all
the way equals minimum
time, approx. 10 seconds;
counter clockwise all the
way equals maximum time,
approx. 15 minutes. (The
unit is shipped with a fac-
tory setting of the minimum
time.) We recommend set-
ting the unit to the minimum
time when adjusting the
SensorLamp’s detection
zone or carrying out a per-
formance test.
Infinitely variable bright-
ness control (Watt-o-matic)
The following functions can
be controlled by means of
the dimmer control:
1) Adjusting screw turned
clockwise all the way
means that the sensor
light fixture is switched
off. Only when move-
ment is detected is the
light switched on at full
power.
2) By setting the adjusting
screw between center
position and turned
clockwise all the way,
the brightness of the
fixture in standby mode
can be adjusted continu-
ously between about
10 watts and a maximum
of 30 watts. This means
that when movement is
detected the light swit-
ches from 20 W main-
tained lighting, for
example, to maximum
output (60 W).
3) Adjusting screw of dim-
mer turned counter
clockwise all the way
and adjusting screw of
lighting controller turned
clockwise all the way: in
this setting, the Sensor-
Lamp is constantly on.
If there is an on/off
switch in the circuit, the
sensor light fixture can
be operated as a normal
light fixture.
Three settings can now be
made on the light fixture’s
sensor lens.
10 – 30 W
approx. 10 sec.–max. 15 min.
10
