Bedienungsanleitung Sterling Elite 2 RS (Seite 29 von 52) (Englisch)

682526

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Sterling Elite2 XS-RS-Plus

7.1.1 ON/OFF KEY SWITCH

The On/Off key switch applies power to the control

system electronics, which in turn supply power to the

scooter motors.

To turn ON Insert the key vertically and turn 90 •

degree clockwise.

To turn OFF scooter, turn key back to vertical position •

and remove, (Fig.7.1.1).

WARNING!

Do not use the on/off key switch to stop the scooter •

unless there is an emergency. (If you do you may

shorten the life of the scooter drive components).

To avoid unexpected or unintentional movement of •

the scooter and to conserve battery power, it is

recommended that the keyswitch is switched Off

when stationary or not being used.

7.1.2 CONTROL LEVER (WIG WAG)

Located by handle bar grips. Your speed as well as

forward and reverse motion is controlled via the control

lever or wig wag.

Gently pull with the right hand or push with the left thumb

to move the scooter in a forward motion. The amount of

movement applied to the lever or wigwag also

proportionally controls the speed of the scooter.

The left hand or right thumb moves the Elite2 in a

reverse motion and also controls the speed of the

scooter in reverse.

The lever will return by itself when released, and you will

stop gently.

Braking is engaged when the Wig-Wag is released.

WARNING!

The factory default setting is described above. Be aware

that it is possible the throttle operation could be reversed

through programming, particularly if you are a second

user.

When stopping the high visibility rear LED braking lights

will illuminate. These also function when the scooter

lights are turned on.

When reversing an audible alarm can be programmed to

come on to warn other vehicles or pedestrians that the

scooter is reversing.

NOTE: The audible reversing alarm is turned off by

default but it can be activated by your Sunrise Medical

dealer or supplier. It is not recommended to deactivate

this feature if it is a statuary requirement of your country/

state.

NOTE: Forward and reverse functions can be swapped

over from right hand operation to left hand operation, via

programming. Please consult your authorised Sunrise

dealer.

NOTE: The handle bar angle can be adjusted to the most

comfortable position by your local authorised Sunrise

dealer.

WARNING!

It is important that you stop the scooter before you

change direction from forward to reverse.

Always turn the scooter control system off via the

keyswitch before you transfer in or out of the scooter.

7.1.3 HORN

The horn will sound while this button is depressed.

7.1.4 HAZARD LIGHTS

With the scooter ON the front and rear LED indicators will

flash simultaneously when this button is pressed.

The visual indicators on the direction buttons on the

keypads will also illuminate.

Press the button again to switch the hazard lights off.

7.1.5 INDICATORS

Pressing the button will illuminate the front and rear LED

indicators in a flashing pattern indicating you are turning

the scooter. On the keypad the visual indicator light will

also flash, and the scooter will emit a beeping tone.

To turn off the indicators press the button again.

Alternatively the direction indicators will automatically turn

off after a distance of approximately 30 meters.

7.1.6 LIGHTS

Pressing the button will turn on the front LED headlight,

and the rear LED lights

NOTE: If the lights are inadvertently left on after use,

removing the ON/OFF key will extinguish the lights

automatically.

WARNING!

Ensure that the lights and indicators are functioning

correctly and all of the lenses are clean, before using the

scooter at night or during poor visibility.

7.1.7 MODE BUTTON

Pressing the Mode button will change the information

shown in the LCD display 7.1.10

Pressing and HOLDING the Mode button will reset •

the trip distance displayed.

Press once to show total distance travelled.•

Press twice to show total trip distance travelled ( LCD •

will display a “t”).

Press a third time to show total hours of use.•

Press fourth time to return to speed display.•

7.1.8 SPEED CONTROL

This allows you to preset your desired scooter speed.

Turn the dial anti-clockwise to slow for very gentle

operation. Turn it clockwise to increase your speed to

maximum

Remember that only with practice will you become a

competent driver. Find a safe, hazard free environment to

practice controlling the scooter and familiarise yourself

with the controls and functions.

WARNING!

For the safety of the operator and other pedestrians,

Sunrise Medical recommends that whilst driving on

footpaths and other pedestrian walk ways, the scooter

preset speed should be set to less than 4 mph/6kph.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sterling Elite 2 RS Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sterling Elite 2 RS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info