Bedienungsanleitung Sterling Elite 2 XS (Seite 40 von 52) (Englisch)

682525

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

40 Sterling Elite2 XS-RS-Plus

9.7 MAINTENANCE-FREE BATTERY CARE PLAN:

Only use an approved Sunrise Medical charger

compatible with the vehicle to be charged.

Charge your batteries every night, regardless of the •

amount of use your mobility device has had during

the day.

Do not interrupt the charging cycle.•

If your mobility device is not required for use, it •

should remain connected to the charger until

required. This will not damage your batteries, as long

as the mains socket/plug is left switched on. Turning

the mains socket/plug off, but leaving the mains cable

plugged in will eventually deplete your battery

charge.

If you leave your vehicle for an extended period •

(more than 1 week), charge the batteries fully and

then disconnect the main battery lead. When the

scooter is to be used again, charge the batteries for a

further 24 hours before use.

Failure to allow for recharge will damage the batteries •

and can lead to shortened distances and premature

failure.

Do not top up the charge of your batteries during the •

day. Wait until the evening for a full overnight charge.

As a general rule, maintenance-free batteries take •

longer to fully charge than wet lead acid batteries.

The battery terminals need to be checked regularly •

for signs of corrosion. If any corrosion is apparent,

then clean the terminals completely (a wire brush is

ideal) and re-grease the terminal using Vaseline

petroleum jelly, not ordinary grease. Ensure that the

terminal nut and bolt, cable clip and exposed cable

are completely covered with jelly.

Following all the points above should result in a •

healthier battery, greater range for the vehicle user

and a longer life for your batteries.

Return the batteries back to Sunrise Medical or •

directly to the battery manufacturer for recycling,

when they no longer hold charge.

9.8 GENERAL CHARGER INFORMATION:

The external charger has been designed to charge two

12 V Gel type batteries connected in series (= 24 V).

9.9 CHARGER SPECIFICATION:

WARNING!

Only use cyclic chargers designed for mobility batteries,

Gel-Type, with a maximum output not exceeding

24V/10A.

For more information about the charger

operation, consult the instructions provided with

the charger.

NOTE: If the charger is not connected to the scooter, it

does not output charge voltage.

WARNING!

It is possible that the charger’s metallic box may slightly

raise in temperature due to use.

9.10 CHARGER SAFETY FEATURES:

The charger has features that prevent hazards or

accidents occurring as a result of connecting batteries the

wrong way round, overheating caused by fault conditions

or attempting to charge wrong voltage batteries.

The majority of chargers are electrically double insulated

and no earth connection is required. Some larger sizes

may be electrically earthed and this will be clearly stated

on the label.

The 3 pin UK mains input plug contains a replaceable

fuse. The rating of this fuse is shown on the charger

label.

WARNING!

Always replace fuses with the same type and size of •

fuse as specified.

Fitting of different fuses can result in damage to the •

charger or failure of the charger to operate properly.

If your charger has been specified for use in •

Continental Europe it will contain a European two pin

plug which does not have a fuse. In this case the

fuse is located inside the case or on the fascia panel

of the charger.

9.11 PROCEDURE FOR CONNECTING THE CHARGER

AND CHARGING:

The scooter can be charged via the charger socket on

the rear of the tiller panel. Fig 9.11.1

Ensure the scooter is switched off.•

First, connect the charger to the scooter.•

Then, connect the charger to the mains supply by •

means of the mains plug and switch on.

The GREEN LED will illuminate to show that the •

power is ON, (Fig.9.11.2).

The YELLOW LED will illuminate to show the •

batteries are charging, (Fig.9.11.2).

The YELLOW LED will switch off when the charge •

cycle is complete, (Fig.9.11.2).

CAUTION!

Do not leave the charger connected to the battery •

with the mains disconnected or switched off. This

could result in damage to your battery being caused

by deep discharge over a period of time.

Always switch off at the mains before disconnecting •

the charger from the scooter.

WARNING!

If an alternative charger has been chosen,

please read the user instruction manual

supplied with that charger as they may differ

from the instructions show above.

Fig.9.11.1

GREEN

LED

YELLOW

LED

Fig.9.11.2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sterling Elite 2 XS Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sterling Elite 2 XS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info