780433
47
Zoom out
Zoom in
Vorherige Seite
1/89
Nächste Seite
46
Inflate the inner tube slightly so that it becomes round and push it
into the tyre all the way round. Make sure not to leave any folds in
the tube.
To finish mounting the tyre start at the point opposite the valve. Us-
ing your thumbs, press the second bead of the tyre over the edge
of the rim as far as you can. Make sure the inner tube does not get
pinched and squashed between tyre and rim. This is prevented by
pushing the inner tube into the tyre hollow with a finger as you work
along.
Work the tyre into the rim by approaching the valve symmetrically
from both sides. Towards the end you will have to pull the tyre vig-
orously downwards to make the already mounted portion of the tyre
slip towards the deepest part of the rim base. This will ease the job
noticeably on the last centimetres.
Check again the proper seat of the inner tube inside the tyre and
press the last stretch of tyre over the edge of the rim by using the
balls of your thumb. It will help you to bring the wheel to rest on your
hip.
If this does not work, you will have to use tyre levers. Make sure the
blunt ends point towards the inner tube and the inner tube does not
get damaged.
Press the valve deep into the tyre so that the inner tube does not get
caught between rim and tyre beads. Does the valve stand upright? If
not, dismount one bead again and reposition the inner tube. To make
sure the inner tube does not get pinched between rim and bead,
inflate the tyre a little and then move it sideways back and forth
between the sides of the rim. While doing this you can also check
whether the rim tape has been displaced.
Inflate the inner tube to the desired pressure. The maximum pressure
is indicated on the side of the tyre.
Check the proper seat of the tyre by means of the “witness line” on
the side of the tyre just above the edge of the rim. Make sure the
witness line is even with the rim edge all the way around the tyre.
The Wheels
47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Stevens MTB 2014 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Stevens MTB 2014

Stevens MTB 2014 Bedienungsanleitung - Deutsch - 91 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info