Bedienungsanleitung Stiebel Eltron BHE 100 Style (Seite 16 von 48) (Deutsch, Englisch, Holländisch, Französisch)

742498

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

OPERATION

Cleaning, care and maintenance

16 | BHE Style www.stiebel-eltron.com

Locking the temperature selector

D0000041743

1 Retainer for contact pieces

2 Contact piece placed in the setting range

 Remove one of the contact pieces from its retainer using a

cutting tool and position it as shown.

Limiting the setting range

D0000041741

 Remove both contact pieces from their retainer using a cut-

ting tool.

D0000041742

 Position the contact pieces, with one at each end of the re-

quired setting range.

 Replace the temperature selector.

5. Cleaning, care and maintenance

Note

Avoid abrasive or corrosive cleaning products.

Clean the surfaces when cold, using a soft cloth and ordinary

cleaning products.

6. Troubleshooting

Problem Cause Remedy

The heated air smells

unpleasant.

This can be caused by

dust during commis-

sioning.

The smell will dissipate within

a few minutes.

The appliance does

not heat up.

The MCB/fuse has re-

sponded/blown.

Replace the fuse/reset the

MCB.

The temperature sensor

is damaged (heating

indicator flashes 3 times

on start-up)

Call your qualified contractor.

The mains voltage to the

appliance is too high

(heating indicator flash-

es 5 times on start-up).

Switch the appliance off. Call

your qualified contractor.

The appliance heats

continuously.

The appliance is subject

to a continuous draught.

Remedy the cause of the

draught.

The temperature setting

was changed.

Set the required room tem-

perature at the temperature

selector

There is a fault with the

power supply.

Disconnect the appliance

from the power supply for

10minutes and then switch it

back on. If the problem occurs

regularly, arrange for your

power supply utility to check

the power supply.

The 24h automatic

function is not work-

ing.

There was a power

failure.

Set the 24h automatic func-

tion again.

The clocks have changed

to summer/wintertime.

Set the 24h automatic func-

tion again.

The elements at the

very top and bottom

don't get as warm as

the rest of the appli-

ance.

The elements at the

top are not completely

filled.

The heating medium expands

when it gets warm. It takes

a little longer for these ele-

ments to heat up.

Dirty marks appear

on the wall around

the appliance.

irty marks are caused

by contaminat

ed air

(candles, cigarette

smoke, poor ventilation,

etc.).

Avoid contaminating the in-

door air.

The boost function is

terminated prema-

turely

The room temperature

is too high. For safety

reasons, the appliance

has automatically

switched off the rapid

heater prematurely.

Switch the appliance off. Wait

at least 10 minutes before

switching the appliance back

on.

If you cannot remedy the fault, notify your qualiﬁed contractor.

To facilitate and speed up your request for assistance, provide the

number from the type plate (000000-0000-000000).

The type plate is located at the bottom, on the right hand side of

the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiebel Eltron BHE 100 Style Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info