Bedienungsanleitung Stiebel Eltron CS 20L (Seite 8 von 20) (Deutsch, Englisch, Holländisch, Französisch)

457710

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

The most important

points in brief

8421.01

Variable heat

outputs

Fan booster

(CS 20 L only)

Thermostatically

controlled

Frost protection with 750 W ON 

Heating with 750 W ON

CS 20

Convection only

CS 20 L

with fan

CS 20 L

OFF

Heating with 1250 W ON

Heating with 2000 W ON ON

Frost protection with 1250 W ON 

Frost protection with 2000 W ON ON 

Heating with 750 W ON ON

Heating with 1250 W ON ON

Heating with 2000 W ON ON ON

Frost protection with 750 W ON ON 

Frost protection with 1250 W ON ON 

Frost protection with 2000 W ON ON ON 

Fan only ON MAX

Unit settings

Heat outputs

depending on heat requirement

Switching the unit off OFF OFF OFF

1. Operating instructions for the user and the professional

The installation and use of electrical appliances

must be carried out with due caution in order

to avoid the risk of fire, electric shock or injury.

The equipment must only be used as described

in these instructions. Any use outside of the

manufacturer recommendations could lead to

damage, fire, shock or injury.

Before using the appliance the instructions

should be read in their entirety and all ap-

propriate handling of the equipment must be

observed.

These instructions should be kept safe-

ly and passed on to any future owner.

In the event of any repair work, hand them

to the qualiﬁ ed installer for his attention.

1.1 Unit description

The CS 20 (L) is supplied complete with a

connecting cable.

Only remove the packaging of the unit and

accessories at the place of installation, taking

note of the additional package.

When unpacking, take care to ensure that no

accessories remain behind in the packaging

material.

Unit design (see page 3)

1 Thermostat knob

2 Heat output switches

3 Fan ON/OFF switch (CS 20 L only)

4 Air outlet grille

5 Fan air outlet grille (CS 20 L only)

6 Recessed grips

7 Foot

8 Hanging bracket

Range of use

The CS 20 (L) is suitable for heating rooms

that are used infrequently, or to supplement

an existing heating system.

These units can be used as mobile free-stand-

ing units with the feet fitted, or alternatively as

wall hanging units.

The use of the heater in bathrooms or similar

damp environments is not permitted. The

heater should not be used outdoors.

The heat requirement of the room should

be matched to the heat output of the unit. In

very small rooms there is a risk of overheating,

damage and fire.

As a free standing appliance it can easily be

used wherever heat is required (when used as a

mobile free standing unit both feet must be fit-

ted before switching on). The connection cable

should not be covered with a carpet or mat,

and should lie outside any ‘traffic area’ where it

could be caught and the heater overturned.

The use of an extension lead should be avoid-

ed. If an extension lead is used it should be of

sufficient cable size for the full rating power of

the heater. It should have a moulded plug and

socket and sufficient preventative measures

should be taken when using it.

The equipment should always stand on a solid

floor, on soft ground the appliance can tilt or

the air grilles could be blocked.

When transporting the appliance it should

be held only by the recessed grips provided

for this purpose (6), under no circumstances

should it be carried by the mains electrical cable.

Function

To heat the air, ambient air entering the unit

through the openings in the base of the unit

is heated, this then flows out by means of

natural convection, via the air outlet grille (4)

at the top.

In the case of the CS 20 (L), this process can

be assisted by using the integral fan to push

heat out through the separate outlet grille (5).

1.2 Operation

The operating controls are located within the

left hand side section of the unit.

Using the thermostat knob (1), the desired

room temperature can be selected between

approximately 5 °C and 35 °C.

The thermostat within the unit then keeps the

ambient air constantly at this set value, by cy-

cling the heating on and off for short periods.

Using the switches (2), three different heat out-

put levels can be selected (750 / 1250 / 2000 W,

see table). This gives increased economy by

adapting to the prevailing heat requirement.

Frost protection

If the unit is used as a frost protection safe-

guard, the thermostat knob should be turned

anticlockwise to the end limit stop and one

of the two selector switches for heat output

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiebel Eltron CS 20L Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info