24
ENGLISH
EN EN
Release the Start/Stop loop G (fig. 5) to stop the
engine.
If the start/stop loop ceases to work, stop
the engine by removing the spark plug
cable from the spark plug. Immediately take the
lawn mower to an authorised workshop for
repair.
CUTTING HEIGHT
Do not set the cutting height so low that
the blade/blades can hit uneven ground.
The cutting height can be adjusted to 3 positions
by moving the wheel axles (fig. 6).
Position 1 = Lowest cutting height
Position 3 = Highest cutting height
LAWN CARE RECOMENDATIONS
Each type of grass has different features and may
thus require different ways to care for the lawn;
always read the instructions on seed boxes for
mowing height for the growth conditions in the
work area.
Keep in mind that most grass is made up of a stem
and one or more leaves. If leaves are fully cut, the
lawn is damaged and growth is more difficult.
The following indications generally apply:
– too low a cut causes grass tears and uprooting,
with a “spotted” aspect;
– in the summer, cutting must be higher to avoid
the ground from drying;
– do not cut wet grass; this could reduce blade
efficiency due to sticky grass and tear the lawn;
– for particularly high grass, initially mow at maxi-
mum admitted machine height followed by a
second mow after two or three days.
MAINTENANCE
IMPORTANT – Regular, careful maintenance is
essential for keeping the safety level and origi-
nal performance of the machine unchanged in
time.
Wear strong working gloves during any cleaning,
maintenance or adjustment operation on the
machine.
Should it be necessary to access the lower part,
only tilt the machine from the side shown in the
engine handbook; following the relative instruc-
tions.
CLEANING
Carefully clean the machines with water after each
cut; remove the grass debris and mud accumulat-
ed inside the chassis to avoid their drying and thus
making the next start-up difficult.
The paintwork on the inside of the chassis may
peel off in time due to the abrasive action of the cut
grass; in this case, intervene promptly by touching
up the paintwork using a rustproof paint to prevent
the formation of rust that would lead to corrosion of
the metal.
CHANGING BLADES
To replace the blade, undo the screw (fig. 7).
Fit the new blade so that the stamped logo is
turned up facing the blade holder (not facing the
grass).
Reinstall as illustrated. Tighten the screw properly.
Tightening torque 40 Nm.
When replacing the blade, the blade screw should
also be replaced.
Each intervention on the blade is best if conducted
at a specialised Centre that has the most appropri-
ate tools.
Only blades with the following codes must be used
on this machine:
81004124/1
Blades must always be marked . Given the prod-
uct evolution, the above mentioned blade may be
replaced in time by others, with similar inter-
changeable and operating safety characteristics.
STORAGE
The same petrol must not remain in the tank for
more than one month.
Thoroughly clean the mower and store it indoors in
a dry place.
SERVICING
Genuine spare parts are supplied by service work-
shops and by many dealers.
We recommend that you take the machine to an
authorised service station for annual servicing,
maintenance and inspection of safety equipment.
For service and spare parts, please contact the
dealer where the machine was purchased.
