32EN
4. Starting is difficult
or the engine runs
erratically
5. Weak engine
performance during
cutting
6. The engine stops
but the light flashes
7. The engine stops
and the light goes off
8. The engine stops
but the light stays on
9. Uneven cut and
poor grass collection
– fuel fault
– forward speed too high in relation to cutting
height
– the safety devices cut in
Electronic card in safety alert,
due to:
– earthed micro-switches
– flat battery
– overload caused by the charge regulator
– badly connected battery (poor contact)
– problems in the engine
– cutting deck not parallel to the ground
– blade cutting badly
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill with new fuel
– check and, if necessary, replace fuel filter
– reduce the forward speed and/or raise
the cutting deck
– check that the conditions allowing starting
are met ( 5.3.7)
Put the key in the «OFF» position and look for
the cause of the problem:
– check connections
– recharge battery
– contact a Licensed Service Centre
– check battery connections
– contact a Licensed Service Centre
– check tyre pressures
– contact a Licensed Service Centre
PROBLEM SITUATION LIKELY CAUSE SOLUTIONS
Key in «ON», engine
running
Key in «ON», engine
running
Key in «ON», engine
running
Key in «ON», engine
running
Key in «ON», engine
running
Key in «ON», engine
running
