Bedienungsanleitung Stiga PARK DIESEL (Seite 12 von 18) (Englisch)

608685

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

4 STARTING AND OPERATION

The machine may not be operated un-

less the engine casing is closed and

locked. Risk of burns and crushing in-

juries.

4.1 Refuelling

Only use diesel which satisfies the minimum re-

quirements of the following specifications:

EN 590

BS 2869 A1 / A2

ASTM D 975 - 1D / 2D

The engine must not be run on rape die-

sel (RME). Contact the engine supplier

for additional information.

1. Open the engine casing.

2. Open the fuel cap (9:X).

Filling fuel above the “Max” level in fig.

9 results in fuel leakage and risk of fire.

3. Fill with diesel to the “Max” level in fig. 9. If

filled above this level the fuel will leak out be-

cause it expands when heated.

4. Close the fuel cap.

Use winter fuel or add kerosene in ambient tem-

peratures below 0°C. See the table below:

Diesel is highly flammable. Always

store fuel in containers that are made

especially for this purpose.

Only fill or top up with fuel outdoors,

and never smoke when filling or top-

ping up. Fill with fuel before starting

the engine.

Never remove the fuel cap or fill with

fuel while the engine is running or still

warm.

4.2 Bleeding

The engine’s fuel system must be bled in the fol-

lowing instances:

• If the fuel tank has been run dry and air has been

drawn into the fuel system.

• After replacing the filter.

Bleed as follows:

1. Fill the tank with fuel.

2. Pump using the hand pump (10:Y) until all air

has been pumped out.

4.3 Level check, engine oil

On delivery, the crankcase is filled with SAE 10W-

40 oil.

Always check the oil level before use to ensure it

is correct. The machine should be standing on

level ground.

Check the oil level as follows:

1. Wipe around the dipstick.

2. Unscrew and pull the dipstick up.

3. Wipe the dipstick.

4. Slide the dipstick down completely and pull up

again.

5. Read off the oil level. The oil level should be at

the “Max” mark as illustrated in fig. 11.

If the oil level is below the “Max” mark in fig. 11,

fill with oil as follows:

1. Unscrew the oil filler cap (11:C).

2. Fill with the necessary amount of oil. Applica-

ble oil types, see “5.4”.

3. Check the level as above.

4. When the level is correct, reinstall the oil filler

cap and tighten.

The oil level must never exceed the “Max” mark as

illustrated in fig. 11. This can cause the engine to

overheat. Drain the oil to the correct level if the oil

level exceeds the “Max” mark.

4.4 Level check, transmission oil

See 5.8.1.

4.5 Safety checks

Check that the results of the safety checks below

are achieved when testing the machine in question.

The safety checks must always be car-

ried out every time before use.

If any of the results below is not

achieved, the machine must not be

used! Take the machine to a service

workshop for repair.

Lowest ambi-

ent tempera-

ture at start °C

Proportion of kerosene

Summer fuel Winter fuel

0 to -10 20% -

-10 to -15 30% -

-15 to -20 50% 20%

-20 to -30 - 50%

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga PARK DIESEL Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info