Bedienungsanleitung Stiga PARK DIESEL (Seite 15 von 18) (Englisch)

608685

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

5.4.1 Oil filter

The oil filter must be cleaned after 1000 hours of

operation and when changing the oil. First drain

the engine oil and install the oil drain plug as

above. Then clean the oil filter as follows:

1. Clean the area around the filter (13:A)

2. Slacken off the screw (13:B) 5 turns.

3. Pull out the oil filter.

Never direct the flow of compressed air

towards the body. The penetration of

air into the blood stream can be fatal.

4. Clean the filter by blowing compressed air in

and out of the filter. See fig. 14.

5. Check/replace the gasket (14:D).

6. Lubricate the gasket (14:D) and slide the filter

in to its limit position.

7. Check that the ends of the tensioner spring

(13:C) lie flush against the filter. Tighten the

screws (13:B).

8. Continue with point 7 according to “5.4 Chang-

ing engine oil” above.

5.5 Engine screws

All screwed joints on the engine must be check-

tightened after 25 hours of operation and then ev-

ery 250 hours of operation.

Exceptions:

• The cylinder head screws must not be touched.

• The fuel injection system’s adjustment screws,

as illustrated in fig. 15, must not be touched.

5.6 Fuel filter

The fuel filter (10:E) must be replaced after every

500 hours of operation.

After replacing, the fuel system must be bled. See

“4.2”.

Check that there is no fuel leakage once the new

filter has been installed.

5.7 Cleaning the fuel tank

During temperature changes water from the air

will condense in the fuel tank. The amount of wa-

ter that condenses increases during large tempera-

ture changes and at high humidity. The water drops

and settles at the bottom of the fuel tank.

Condensation should be drained from the fuel tank

as necessary and at least once a year.

The engine must be cold when the con-

densation id drained, otherwise there is

a risk of fire.

Smoking, fires, sparks and other heat

sources are prohibited in the proximity

when the condensation is drained.

There is a fire risk.

Drain the condensation as follows:

1. Detach the drain hose from the its mounting un-

der the rear bumper. See fig. 16.

2. Turn the drain cock (16:F) in its mounting to fa-

cilitate opening.

3. Insert the drain hose into a suitable container.

4. Open the drain cock and drain until all the water

has run out.

5. Close the drain cock and reset the cock and hose

in reverse order.

6. Dispose of the drained fluid according to local

regulations.

5.8 Transmission, oil (4WD)

The oil in the hydraulic power transmission must

be checked/adjusted and changed at the intervals

given in the table below.

Type of oil: Synthetic oil 5W-50.

Oil quantity when changing: approximately 3.5 li-

tres.

5.8.1 Check – adjustment

1. Place the machine on a flat surface.

2. Read off the oil level in the reservoir. See fig.

20. The level should be level with the line.

3. If necessary, top up with more oil.

5.8.2 Draining

1. Run the machine at variable speeds for 10-20

minutes to heat up the transmission oil.

2. Position the machine completely horizontally.

3. Pull out both disengagement levers according to

fig. 7:A, B.

4. Place one container under the rear axle and one

under the front axle.

5. Open the oil reservoir by removing the cover.

Only a 3/8” square drive may be used

for the oil plug. Other tools will damage

the plug.

6. Remove the oil plug from the rear axle. Clean

the hole and use a 3/8” square drive. See figure

18.

7. Remove 2 drain plugs from the front axle. Use

a 12 mm socket. Allow the oil in the front axle

and pipes to run out. See fig. 19.

8. Check that the gaskets on the drain plugs of the

front axle are intact. See fig. 19. Reinstall the

plugs. Tightening torque: 15-17 Nm.

Action

1st time Then at

intervals

Hours of operation

Checking – adjusting level. - 50

Changing the oil. 5 200

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga PARK DIESEL Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info