Bedienungsanleitung Stiga Silent (Seite 11 von 18) (Englisch)

608629

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

ENGLISH

10.2Engine casing (2:U)

In order to access the fuel cock, battery

and engine, the machine has an engine

casing that can be opened. The engine cas-

ing is locked with a rubber strap.

The engine casing is opened as follows:

1. Undo the rubber strap (2:V) at the front edge of

the casing.

2. Carefully lift the engine casing back.

Close in the reverse order.

The machine may not be operated un-

less the engine casing is closed and

locked. Risk of burns and crushing in-

juries.

10.3Battery

See “14.8 Battery”.

10.4Seat (fig. 4)

1. Remove the following components from the

seat bracket:

• 4 Nuts (for transport locking, not used).

•4 Screws.

• 4 Shoulder washers.

2. Position the seat over the mounting in the seat

bracket.

3. Install the shoulder washers on the screws.

4. Insert the screws with the attached shoulder

washers through the slots in the seat bracket and

the holes in the seat plate. Screw the seat into

place.

Tightening torque: 9±1.7 Nm.

If the screws are tightened more than

9±1.7 Nm, the seat will be damaged.

5. Check that the seat moves easily in the slots in

the bracket.

The seat can be folded. If the machine is parked

outside when it is raining, fold the seat forward to

protect the seat cushion from getting wet.

10.5Steering wheel

In order to minimise the axial play in the steering

column, the shim washers (5:B) and/or (5:C) must

be installed on the steering column between the

steering column jacket and the bracket as follows.

1. Install the steering column jacket on the steer-

ing column and secure by knocking in the ten-

sion pin (5:A) approximately 1/3 of its length.

2. Pull the steering column jacket and the steering

column up.

3. From the outside, check whether no washers,

the 0.5 mm washer, the 1.0 mm washer or both

washers can be inserted into the gap. The wash-

er/washers must not be forced in, as there must

be a little axial play.

4. Pull out the cotter pin and dismantle the steering

wheel jacket.

5. Install the washer/washers in accordance with

point 3 above.

6. Install the steering column jacket on the steer-

ing column and secure by knocking in the ten-

sion pin fully. Use a counterhold.

10.6Towing plate

Install the towing plate (6:I) at the rear of the ma-

chine. Use the screws and the nuts (6:J, H).

Tightening torque: 22 Nm.

10.7Deck mounts

This only describes installation on the right-hand

axle. Same procedure must be carried out on the

left-hand axle.

1. Lubricate the axle ends and the deck mount’s

bearing surface with oil before installation.

2. Install the deck mounts to the machine accord-

ing to fig. 7.

3. Install the locking pin (7:K) in the hole in the

axle.

10.8Tyre pressure

Check the air pressure in the tyres. Correct air

pressure:

Front: 0.6 bar (9 psi)

Rear: 0.4 bar (6 psi)

10.9Accessories

For the installation of accessories, see separate in-

stallation guide supplied with each accessory.

Note: The cutting deck is regarded as an accessory

here.

11 DESCRIPTION

11.1 Drive

The machine is rear wheel drive.

The rear axle is equipped with a hydrostatic trans-

mission with infinitely variable forward and re-

verse gear ratios.

The rear axle is also equipped with a differential to

facilitate turning.

Front mounted tools are driven by drive belts.

11.2 Steering

The machine is articulated. This means that the

chassis is divided into a front and a rear section,

which can be turned in relation to each other.

The articulated steering means that the machine

can turn around trees and other obstacles with an

extremely small turning radius.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stiga Silent Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info