Bedienungsanleitung Stihl BG86 (Seite 7 von 72) (Englisch)

52120

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

BG 56, BG 56 C, BG 66, BG 66 C, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C

English

Fueling Instructions

Before Starting

Starting

Warning!

Fuel your power tool in well-ventilated

areas, outdoors. Always shut off the

engine and allow it to cool before refu-

eling. Gasoline vapor pressure may

build up inside the fuel tank depending

on the fuel used, the weather condi-

tions and the tank venting system.

In order to reduce the risk of burns and

other personal injury from escaping gas

vapor and fumes, remove the fuel filler

cap on your power tool carefully so as

to allow any pressure build-up in the

tank to release slowly. Never remove

the fuel filler cap while the engine is

running.

Select bare ground for fueling and

move at least 10 feet (3 m) from the

fueling spot before starting the engine.

Wipe off any spilled fuel before starting

your machine.

Warning!

Check for fuel leakage while refueling

and during operation. If fuel leakage is

found, do not start or run the engine

until the leak is fixed and any spilled

fuel has been wiped away. Take care

not to get fuel on your clothing. If this

happens, change your clothing

immediately.

Unit vibrations can cause

an improperly tightened

fuel filler cap to loosen or

come off and spill quanti-

ties of fuel. In order to

reduce the risk of fuel

spillage and fire, tighten

the fuel filler cap by hand

as securely as possible.

Warning!

Always check your power tool for

proper condition and operation before

starting, particularly the throttle trigger,

throttle trigger interlock and stop switch.

The throttle trigger must move freely.

Never attempt to modify the controls or

safety devices.

Warning!

Never use a power tool that is damaged

or not properly maintained.

Warning!

Check that the spark plug boot is

securely mounted on the spark plug – a

loose boot may cause arcing that could

ignite combustible fumes and cause a

fire.

Warning!

Keep the handles clean and dry at all

times; it is particularly important to keep

them free of moisture, pitch, oil, grease

or resin in order for you to maintain a

firm grip and properly control your

power tool.

Warning!

Start the engine at least 10 feet

(3 meters) from the fueling spot, out-

doors only.

Warning!

Your power tool is a one-person

machine. Do not allow other persons in

the general work area, even when

starting.

For specific starting instructions, see

the appropriate section of your manual.

Place the power tool on firm ground or

other solid surface in an open area.

Maintain good balance and secure

footing.

Warning!

To reduce the risk of injury from loss of

control, do not attempt to "drop start"

your power tool.

Warning!

When you pull the starter grip, do not

wrap the starter rope around your hand.

Do not let the grip snap back, but guide

the starter rope to rewind it properly.

Failure to follow this procedure may

result in injury to your hand or fingers

and may damage the starter

mechanism.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl BG86 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stihl BG86

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info